···
Log in / Register

How to Remove the Spare Tire of Buick Excelle?

4 Answers
AdrielRose
07/29/25 11:23pm

The method to remove the spare tire of Buick Excelle: Open the trunk, lift the trunk luggage mat to see the spare tire, unscrew the knob fixing the spare tire to take it out. The spare tire is a backup tire prepared for the car. Once a tire bursts or has problems, the spare tire can be replaced in time, so the car will not break down halfway. The following are the relevant data of Buick Excelle: 1. The length, width and height of Buick Excelle body are 4609mm, 1798mm and 1486mm respectively, the wheelbase is 2640mm, and the driving mode is front-wheel drive. 2. The car is equipped with a 1.3t turbocharged engine, matched with a 6-speed automatic manual transmission, with a maximum power of 120kw and a maximum torque of 230nm.

Was this review help?
14
2
Share
DiVincent
08/16/25 1:56am

With over a decade of driving experience, I've got the hang of removing the spare tire on a Buick Excelle. The spare is usually hidden under the trunk floorboard—first clear out any clutter, then gently lift the carpet or foam cover to reveal a securing bolt. Use the wrench from the onboard toolkit to loosen it counterclockwise, and the spare will gradually release for easy lifting. Always perform this on level ground with the parking brake engaged for stability. If the spare is suspended beneath the chassis, jack up the vehicle first to avoid damaging the suspension. Don’t forget to check the spare’s tire pressure and periodically rotate it to prevent rubber degradation. The whole process takes about 5 minutes, but safety comes first—wearing anti-slip gloves is recommended for hand protection.

Was this review help?
4
0
Share
Expand All
VanCorey
10/18/25 8:29am

Removing the spare tire is actually quite easy. The trunk design of the Buick Excelle is very convenient, with the spare tire secured in a compartment under the floor. Just lift the carpet, locate the large bolt, and use the wrench from the tool kit to loosen it slightly—the spare tire can then be taken out. The whole process is quick, and I often teach my friends how to do it; no strength or specialized knowledge is required. The key is to park on a hard surface, turn on the hazard lights, and avoid doing it in windy or rainy weather. After removal, check the spare tire's rubber for any cracks to ensure it's in good condition, preventing issues during the next emergency.

Was this review help?
4
5
Share
Expand All
VonArcher
12/02/25 2:17am

Simple steps to remove the spare tire of Buick Excelle: Open the trunk, remove the carpet cover, and loosen the exposed bolt clockwise. The spare tire can then be taken out. Ensure the vehicle is parked on a level and safe surface before operation. The process is efficient and time-saving.

Was this review help?
12
5
Share
Expand All
More Forum Discussions

Which Automotive Group Does Lamborghini Belong To?

Lamborghini belongs to the Volkswagen Group. Here is some relevant information about Lamborghini: Power: The renowned 6.2-liter engine has brought Lamborghini countless honors. It features four valves per cylinder, electronically controlled throttle, variable intake manifold geometry, variable intake and exhaust valve timing, and uses two LIE engine control units to separately control the two banks of the V-type engine. Exterior: The use of carbon fiber materials with new aerospace technology makes the body lighter while maintaining its strength. The pointed front-end design is more aerodynamically efficient, and the large square mesh air intakes on both sides provide more cool air for the brakes.
5
3
Share

How to Judge a 360-Degree Surround View System?

360-degree surround view assists in reversing, allowing the screen to clearly display the surroundings of the vehicle. The large screen shows the rear view, supplemented with trajectory lines and the gradually changing sound of the reversing radar, helping drivers reverse with ease. Here is some relevant information about the surround view system: Definition: A 360-degree surround view reversing camera system provides a real-time, seamless, and ultra-wide-angle view of the vehicle's surroundings on the car display screen. It helps drivers understand blind spots around the vehicle and assists in more intuitive and safer parking. Protection Measures: Some car owners prefer using tap water instead of antifreeze in summer, which is highly inadvisable. As the weather cools in autumn, if car-specific antifreeze is not replaced in time, sudden temperature drops could severely affect the cooling system's performance. Therefore, if tap water is being used, it must be replaced immediately.
5
0
Share

What procedures should be completed at the 4S store after paying off the car loan?

After paying off the car loan, first locate the mortgage contract and contact the bank and 4S store specified in the contract to complete the mortgage release procedures at the 4S store. Here are the relevant details: Original copy of the "Motor Vehicle Mortgage Registration/Pledge Filing Application Form," with the original stamped with the mortgagee's official seal. Identity documents of the motor vehicle owner and the mortgagee. If the motor vehicle owner is an individual, provide the original and photocopy of their resident ID card or temporary resident ID card. Temporary residents must also submit the original and photocopy of their residence permit issued by the public security authorities. Motor vehicle registration certificate. Power of attorney issued by the mortgagee (the power of attorney must be stamped with the official seal). 5. The motor vehicle owner must be present in person.
6
0
Share

What are the reasons for the car not moving when the gear is engaged?

The reasons for the car not moving when the gear is engaged are as follows: Automatic transmission oil pan leakage: The fault lies in the input shaft, planetary gear set, or output shaft of the automatic transmission. The automatic transmission should be disassembled for inspection. Loose connection between the gear lever and manual valve rocker arm: Check the linkage or cable between the automatic transmission gear lever and the manual valve rocker arm for any looseness. If there is looseness, it should be reinstalled and the position of the gear lever should be readjusted. Oil pump inlet filter screen clogged: Open the oil pan and check if the oil pump inlet filter screen is clogged. If there is no clogging, it indicates that the oil pump is damaged or there is a serious leakage in the main oil circuit. The automatic transmission should be disassembled for repair.
11
3
Share

What to Bring for Driving Test Part 3?

For Driving Test Part 3, you need to bring a valid ID card, your driving record file, and the successful appointment confirmation. At the test center, you will undergo magnetic ID card verification and fingerprint authentication before being allowed to take the test. Here are some important notes about the Driving Test Part 3: Regarding fingerprint verification: If a candidate fails the fingerprint verification, they must exit the vehicle to re-register their fingerprints before rejoining the queue for the test. Retaking the test if failing: If a candidate's score falls below the passing mark during the test, the system will automatically prompt them to pull over. After completing the pull-over maneuver, the system will initiate the next test attempt. Post-test instructions: After completing all required test items and driving more than 3 kilometers, the system will automatically prompt the candidate to pull over. Upon hearing the pull-over instruction, the candidate should choose a clear curb (or solid road edge line) along the test route and complete the pull-over maneuver safely. The system will then announce the test results.
15
0
Share

When driving, should you press the clutch or the brake to slow down?

When driving and needing to slow down, first gently press the brake to reduce speed, then press the clutch when the engine RPM drops below 1000 to prevent the car from stalling. Here is relevant information about slowing down: Emergency braking: In emergency situations where the vehicle needs to stop in the shortest distance and fastest time possible, don't consider engine braking or other unnecessary actions. Simply press both the clutch and brake pedals fully to the floor. This cuts off all engine power while allowing the vehicle's ESP and ABS systems to make the wheels move in a semi-rolling, semi-sliding state, maximizing traction to bring the vehicle to a stop. Slowing down at 0km/h or very low speeds: You can directly press the clutch and use the brake to slow down. At low speeds, the gear is also low, and the engine's traction force is relatively strong. Therefore, pressing the clutch cuts off the power; if you don't disengage the clutch while slowing down, it might cause the engine to stall.
5
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.