How to remove the small round mirror attached to the car's rearview mirror?

[DeMaya]

The method to remove the small round mirror attached to the car's rearview mirror is: 1. Soak the adhesive area of the small round mirror with alcohol; 2. Use a hairdryer to blow hot air on it; 3. After blowing hot air for a while, the small round mirror will fall off, and any remaining adhesive can be gently wiped off with alcohol. The car's rearview mirror is a convex mirror with a spherical surface and varying radii of curvature. The reflected image is smaller than the actual view, but the field of vision is larger. Located on the left and right sides of the car's front, it allows the driver to see the rear, side, and lower parts of the car, significantly expanding the driver's field of vision. It plays a crucial role in lane changes, overtaking, reversing, turning, parking, and driving.

[LeLiam]

Want to remove the small round mirror stuck on your rearview mirror? Don’t pry it off by force! Not only can you tear the adhesive, but you might also scratch the precious coating on your mirror. The safest method I’ve found is using a hairdryer or heat gun (set to the lowest setting, and don’t get too close!) to gently warm the adhesive behind the small round mirror. Once the adhesive softens, it becomes much easier to handle. Then, use a fishing line or sturdy dental floss to slide between the mirror and the small round mirror, slowly sawing it back and forth. After separation, the sticky residue left on the mirror is the most annoying part. Dab a non-woven or cotton cloth with medical alcohol, essential balm, or a dedicated adhesive remover spray, place it over the residue for a short while, and then gently wipe it off in circular motions. Remember, be gentle throughout the process—the mirror surface is delicate.

[FaithRose]

I've got some experience removing these little things. The best time is after a summer scorcher when the sun has softened the adhesive - just gently pry up a corner. If it's winter or you're in a hurry, use whatever you have at home: blast it with a hairdryer for a minute to heat it up, then while it's warm, slowly lift it from the edge using your fingernail or a plastic card (old bank cards or membership cards work). The real headache is cleaning the leftover adhesive - don't rush for steel wool! Get some medical alcohol from the pharmacy or use essential balm at home. Soak a small piece of wet wipe, place it on the adhesive marks to dissolve for a few minutes, then wipe it away bit by bit. If that doesn't work, try mixing some neutral dish soap with warm water to clean it. After cleaning, remember to wipe it down again with a clean damp cloth to prevent any residue from corroding the mirror surface.

[ColemanAnn]

Want to remove the small round mirror? The key is dealing with that strong double-sided adhesive. My go-to method is simple: fill a plastic bag with hot water (not too hot to prevent cracking), press it against the back of the small round mirror for a few minutes to heat it up. Once the adhesive softens, gently slide a thin thread into the gap and slowly pull it back and forth to peel it off. Then, tackle the remaining adhesive by sticking a piece of transparent tape upside down (sticky side up) onto the residue, press repeatedly and quickly peel it off to remove much of the glue. If there are still marks left, spray some makeup remover oil commonly used by women or kitchen degreaser, wait a moment, and wipe with a cloth. This method is gentle and won't damage the mirror's coating—tested and proven effective.