How to Remove the Seats of Volkswagen Bora?

[StJeffrey]

Move the seat to the frontmost position and locate the two screws at the rear of the slide rail. Remove them, then move the seat to the rearmost position and remove the two screws at the front of the slide rail to detach the seat. Forcefully lift the left side of the seat upwards, then do the same for the right side, and pull the seat forward to remove it. Remove the two headrests on the rear backrest, and you will see four round holes securing the headrests. Remove all of them, then forcefully lift the backrest upwards to detach it. Use a flashlight to look inside the round holes; you will see clips. Insert a screwdriver into the outer side of the round hole and gently pry inward, then pull the round hole outward to remove it.

[LaManuel]

I was quite nervous the first time I removed the seat of my Volkswagen Bora, as I only intended to clean the carpet myself but found the process more involved than expected. You need to disconnect the negative terminal of the car battery first to prevent electrical shorts, especially since there are airbag sensors under the seat—touching them carelessly can be dangerous. Prepare a socket wrench, preferably one with an extension bar for better reach. The seat is usually secured by four bolts at the bottom, hidden behind plastic trim panels; carefully pry off the panels first to avoid scratching the interior. Disconnect all wires and connectors gently, as Volkswagen's connectors are quite delicate. After loosening the bolts, lift the seat slowly without applying too much force to prevent damaging the sliding rails. Once cleaning is done, ensure all connectors are properly reattached before securing the seat during reinstallation. The whole process takes about 20 minutes, but beginners should consider asking a friend for assistance—safety comes first. Also, remember that disconnecting the battery resets the radio settings, something I only realized afterward.

[JudahRose]

As someone who frequently works on cars, I can remove a Bora's seats very quickly. The standard procedure is: disconnect the battery before starting to avoid accidental airbag deployment. Have a socket wrench ready, usually 13mm in size. There are plastic trim panels at the bottom of the seat, pry them open to expose the bolts. Typically four bolts hold it in place, use the wrench to loosen and remove them. Don't forget to disconnect the electrical connectors, being careful not to pull on the wiring harness or rails. All Volkswagen vehicles share this universal design, making the process similar. When reinstalling, ensure proper alignment and that seatbelt and sensor connections are secure. I recommend checking seat fasteners every six months to prevent aging-related loosening. Safety first is the principle - being professional always saves trouble.

[McPeyton]

Removing the Bora's seats is actually quite easy with this method: Prepare a socket wrench to lift the trim panel under the seat. There are usually four bolts—loosen them all and disconnect all the wiring plugs. Carefully lift the seat out. When reinstalling, avoid crushing the carpet; just align it properly. Don't skimp on tools—simple tools can get the job done.