How to Remove the Roof Lining of a Magotan?

1 Answers
MacMariana
07/29/25 7:55pm
Start from the driver's seat and proceed counterclockwise to remove the seats one by one. Use a T25 for covers and screws connected to the body, and a T20 for handles, sun visors, and the glasses compartment. Open the glasses compartment, and you will see two 'coin slots' as shown in the image below. Insert a flat-head screwdriver or an interior tool to pry them open, revealing two screws. For the rear foot of the roof lining, there is something resembling a crab's belly shell. It was later discovered that it is secured by clips. It is recommended to use a specialized interior tool here. After moving and tilting the front seats back, the left front of the roof lining is at the bottom, and the right front is at the top. Remove it from the right front door. Between the two yellow damping plates, there is nothing, but above the B-pillar, there is a wavy steel plate, which might be the steel beam that the 2006 model should still have.
Was this review help?
20
5
Share
More Forum Discussions

What are the causes of difficult cold starts in engines?

The causes of difficult cold starts in engines are: 1. Air leaks in the intake system; 2. Fuel pressure is too low; 3. Clogged air filter; 4. Faulty coolant temperature sensor; 5. Faulty mass airflow sensor; 6. Malfunctioning idle control valve or auxiliary air valve; 7. Cold start injector not working; 8. Fuel injector leakage; 9. Incorrect ignition timing; 10. Broken wiring from the starter switch to the ECU; 11. Cylinder compression pressure is too low. Methods to address starting difficulties include: 1. Check the battery condition; 2. Use suitable engine oil; 3. Replace spark plugs promptly. Methods for warming up the engine: 1. Drive after 30 seconds to 1 minute of idling; 2. Maintain low-speed driving; 3. Once the engine reaches normal operating temperature, drive as usual.
4
2
Share

How to Drive in a Straight Line?

The method to drive in a straight line is: 1. Hold the steering wheel steadily and straight while driving, avoiding large turns; 2. Find suitable reference points on the road and focus your gaze ahead. Precautions for novice drivers include: 1. Adjust the seat position and rearview mirrors before driving, and fasten the seatbelt; 2. Turn the ignition key and wait for the computer self-check to complete before starting; 3. Ensure the handbrake is released before driving; 4. Keep your heel on the floor when pressing the pedals, slowly release the clutch and gently press the accelerator when starting; 5. Always use turn signals and reduce speed when turning or changing lanes; 6. When driving on clear roads, look straight ahead at a distance of 100 meters, not just at the immediate front of the car; 7. Use hazard lights when parking by the roadside; 8. Engage the handbrake when parked; 9. Stay focused while driving; 10. Avoid occupying two lanes for extended periods.
4
2
Share

What is the difference between fully synthetic and semi-synthetic engine oil?

The differences between fully synthetic and semi-synthetic engine oils are: 1. Different base oils: Fully synthetic oil is a mixture of Group III, IV, and V base oils; semi-synthetic oil uses Group III base oil. 2. Different replacement intervals: Fully synthetic oil should be replaced once a year or every 10,000 kilometers during use; semi-synthetic oil should be replaced every six months or every 7,500 kilometers during use. Engine oil, also known as engine lubricant, serves the following functions: 1. Cooling and temperature reduction; 2. Sealing and leak prevention; 3. Cleaning and purification; 4. Shock absorption and buffering; 5. Lubrication to reduce wear; 6. Rust and corrosion prevention; 7. Component protection.
17
0
Share

What transmission does the Changan Eado use?

The Changan Eado uses a 7-speed dual-clutch transmission. The Changan Eado is a compact 4-door 5-seater sedan with body dimensions of 4730mm in length, 1820mm in width, and 1505mm in height, with a wheelbase of 2700mm and a fuel tank capacity of 53 liters. It is equipped with a 1.4T turbocharged engine, delivering a maximum power of 116 kW at 5500 rpm and a peak torque of 260 Nm between 1500 to 4000 rpm. The drivetrain is front-wheel drive, featuring MacPherson strut front suspension and a torsion beam rear suspension.
12
3
Share

What Causes the Plastic Friction Sound When Turning the Steering Wheel?

The reasons for the plastic friction sound when turning the steering wheel are: 1. Friction between plastic components; 2. Issues with the steering wheel airbag clock spring; 3. Aging of the steering tie rod ball joint; 4. Loose or damaged stabilizer bar; 5. Problems with the shock absorber thrust bearing; 6. Improper tension or aging of the power steering belt. The solutions for the plastic friction sound when turning the steering wheel are: 1. Apply some grease to the steering wheel airbag clock spring or replace it; 2. Replace the steering tie rod ball joint; 3. Add shims to the stabilizer bar or replace it; 4. Apply grease to the shock absorber thrust bearing or replace the part; 5. Adjust the belt tension or replace the belt.
17
2
Share

What is the unladen ground clearance of the Levin?

The unladen ground clearance of the Levin is 105mm. Ground clearance refers to the distance between the lowest point of the vehicle (excluding the wheels) and the supporting surface when the car is fully loaded and stationary. The Levin is a compact 4-door, 5-seater sedan with the following body dimensions: length 4640mm, width 1780mm, height 1455mm, and a wheelbase of 2700mm. The Levin is equipped with a 1.2T turbocharged engine and a CVT continuously variable transmission, delivering a maximum power of 85 kW and a maximum torque of 185 Nm. It features front-wheel drive, with a MacPherson strut independent suspension at the front and an E-type multi-link independent suspension at the rear.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.