How to remove the rearview mirror of Changan CS35?
2 Answers
The method to remove the rearview mirror of Changan CS35 is as follows: pinch the cylinder behind the rearview mirror, then rotate it counterclockwise by 45 degrees to remove it. When installing, rotate it clockwise by 90 degrees. However, it is recommended not to remove the rearview mirror easily, as there is a certain probability of pulling down the inner glass. Relevant information about Changan CS35 is as follows: 1. The overall exterior design of Changan CS35 is upright and powerful, with smooth, sharp, and clean lines. The front face design is highly impactful, with a large grille that contains a sense of refinement. 2. The headlights adopt a knife-cut design style, paired with naturally smooth curved decorative rings and barrel-style lens covers; the front wheel arch lines extend downward and cleverly integrate with the lower edge of the fog lights. 3. The new Changan CS35 is equipped with Bosch's latest ninth-generation ESP system, tire pressure monitoring, an upgraded inCall intelligent vehicle interconnection system, and adds functions such as right-side blind spot monitoring and passenger seat belt reminder.
Last time I disassembled the rearview mirror of my Changan CS35 by myself, mainly to save some repair costs. The steps were pretty straightforward: First, use a plastic pry tool or a thin tool to carefully pry the mirror from the bottom—avoid using metal tools to prevent scratches. After removing the mirror, you’ll see several small screws inside; loosen them with an electrician’s screwdriver. If it’s an electric version, remember to unplug the wiring connector—don’t yank it forcefully. Finally, the entire housing can be pulled out. Throughout the process, be careful to protect the glass and circuitry, and wear gloves to avoid cuts. If it gets stuck, don’t force it—patiently check the clip positions. After finishing, I found it relatively simple, but beginners should watch online videos first to get familiar.
