How to remove the rearview mirror of Changan CS35?

[GriffinLynn]

The method to remove the rearview mirror of Changan CS35 is: 1. Pinch the cylinder behind the rearview mirror; 2. Rotate it counterclockwise by 45 degrees to remove it. The Changan CS35 is a compact SUV with body dimensions of: length 4170mm, width 1810mm, height 1670mm, wheelbase 2560mm, fuel tank capacity 52l, and trunk capacity 510l. The Changan CS35 is equipped with a 1.5T turbocharged engine, with a maximum power of 115kw, maximum power speed of 5000rpm, and maximum torque of 215nm, paired with a 5-speed manual transmission.

[VonRose]

To remove the rearview mirror of the Changan CS35, you need to prepare plastic pry tools and a screwdriver. First, adjust the mirror angle to the outermost position to expose the edge of the mirror frame. Insert the pry tool into the gap at the bottom of the mirror and gently lift to release the clips—avoid forcing it to prevent cracking the mirror. After removing the mirror, you'll find three cross-head screws hidden inside; unscrew them one by one. Then, carefully pry open the clips along the seam of the mirror housing to separate it. Be cautious of the wire connected to the heating function—pinch the connector and unplug it to fully detach. The entire disassembly process takes about 15 minutes. The plastic clips on the mirror and housing are particularly fragile, so it's best to purchase spare parts beforehand.

[LaMakayla]

Last time I replaced the CS35 rearview mirror myself, here's how I did it: First, prepare a small Phillips screwdriver and a pry tool. If you don't have those, a bank card will work too. Sit in the driver's seat and adjust the mirror to the position closest to the door, which will maximize the gap at the edge of the mirror. Then, starting from the bottom of the mirror, carefully pry it up about half a centimeter with the tool. Feel for the spring clip inside and press it downward to remove the mirror. Next, remove the three screws securing the bracket, use your fingernail to pry open the housing from the gap, and finally disconnect the wiring connector. When reinstalling, remember to test the heating function - once I didn't plug it in tightly enough and the heating didn't work. I recommend not doing this on rainy days as the mirror can be slippery and prone to breaking if dropped.

[MacIris]

The CS35 rearview mirror removal process consists of five steps: adjust the angle to expose the frame, pry open the mirror clips, remove the internal screws, separate the housing, and disconnect the wiring. The key is to proceed slowly, as the clips at the bottom of the mirror are particularly fragile and can break with excessive force. The housing clips are hidden behind the dust seal strip, and using a fingernail to pry them open is safer than using metal tools. The wiring connector has a small latch that must be pressed down before it can be pulled out. The only tools needed are a screwdriver, and a hard plastic sheet can be used instead of a pry tool. After removal, remember to cover the screw holes of the mounting bracket with tape to prevent debris from falling into the door. If installing an electric folding version, an additional controller needs to be connected, while the standard version can simply be reinstalled in reverse order.