How to Remove the Rearview Mirror of a Magotan?
4 Answers
Take out a small flathead screwdriver and gently insert it into the gap to gradually widen it. Then locate the clip inside and gently pry it open. Use your hand to gently lift the tweeter upwards, being careful to do it lightly as these white clips are very fragile and can break easily. Exercise caution during the operation. Follow the wiring harness of the tweeter to find the position of the wiring harness connector, then gently pull the connector off by hand. Remove the screws of the rearview mirror. Follow the wiring harness of the rearview mirror to locate the wiring harness connector on the door panel. Take out a small flathead screwdriver and use it to remove the wiring harness connector.
I've got quite some experience with removing the rearview mirror on a Magotan. Last time I did it myself, I found that preparing the right tools is key: a screwdriver and a plastic pry bar are practical—avoid metal tools to prevent scratching the paint. First, lower the window a bit for easier access. Removing screws is usually the first step—locate the fixing screws on the mirror housing and gently unscrew them. Remember, if it's the electric version, disconnect the battery's negative terminal to avoid short circuits when handling the wiring. When prying open the housing, take it slow—the clips are tight, so use the plastic pry bar to carefully lift one side without forcing it, or you might break it. After opening, check the wiring connectors to avoid damage, then gently remove the mirror part. After reassembly, test the functions to ensure smooth mirror adjustment and no looseness. The whole process takes about 20 minutes—patience and attention to detail are crucial. Regular removal also helps clean internal dust and prevent part aging. Safety first: wear gloves, work on a stable surface, and don't rush.
Be extra careful when removing the side mirror yourself to avoid issues. I usually park the car in a safe location, turn off the engine and power to prevent any accidental contact risks. Then ordinary tools will suffice - after removing the mounting screws with a screwdriver, the housing might be tightly adhered, so gently pry it open without using excessive force. Pay special attention to the wiring part; for power mirrors, slowly disconnect the connector to avoid damaging internal circuits. After removal, take the opportunity to check if the mirror glass has cracks or looseness, and repair or replace it promptly. The entire process shouldn't exceed 15 minutes. When reassembling, align and snap the clips securely to ensure stability without wobbling. Avoid doing this in rain or snow as moisture can affect functionality. In short, prioritize safety - regular maintenance checks can extend component lifespan. Spending a little on repairs is better than dealing with sudden failures.
As a DIY car repair enthusiast, removing side mirrors is so much fun. Required tools: start with a small wrench or Phillips screwdriver, plus plastic trim removal tools. First locate the screw positions at the bottom of the housing, loosen and remove them. Gently pry open the edge clips to reveal the mirror glass and wiring. Don't forget to disconnect power - press the release button on the wiring connector to remove it. The whole process takes just 10 minutes. After removal, clean and lubricate the moving joints to prevent rust. Key tip: using plastic pry tools makes it easier and avoids scratches. Regular disassembly for mirror maintenance can save repair costs. Simple operation with lots of fun!
