How to Remove the Rear Seats of Haval H6

[DiCaden]

Haval H6 rear seat removal method: 1. Enter the car and you can see that the screws under the rear seats are protected by plastic covers, which can be pried off directly; 2. After removing the plastic covers, the screws inside will be visible; 3. Use a socket wrench to unscrew the screws; 4. Once both screws are removed, the seat can be taken out. The Haval H6 has a length of 4615mm, width of 1860mm, height of 1720mm, and a wheelbase of 2680mm. It is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 224ps, maximum power of 165kw, and maximum torque of 385nm.

[KimberlyMarie]

I've removed the rear seats of my Haval H6 several times, mainly to install seat covers. First, lift the front half of the seat cushion upwards to locate the front clips. The clip near the door side is particularly tight, so you need to use your knee to brace against the bottom of the seat for leverage. After removing the seat cushion, there are fixing bolts on both sides at the lower part of the backrest. Use a 14mm socket wrench to unscrew them, then lift the seat backrest upwards to remove it entirely. Throughout the process, be careful not to scratch the seat fabric with tools, and avoid using excessive force on the plastic clips. When reinstalling, first align the bottom slots and then press down firmly until you hear a click, indicating it's securely locked. Doing it yourself is actually simpler than you might think, and it can be completed in about half an hour.

[Gabriel]

Removing the rear seats of the Haval H6 is actually not difficult, I often help friends with this. The first step is to locate the two buckles at the front of the seat cushion, where the seat meets the floor. Lift the middle of the seat cushion upward with your palm until you hear a click, which means the front buckles are unlocked. Then continue lifting the rear part to remove the seat cushion. When removing the backrest, pay attention to the fixing bolts on both sides and loosen them counterclockwise with a socket wrench. It's best to have two people for removing the backrest - one lifts the seat back while the other supports the car body to avoid scratches. After removal, check if the buckles are deformed. When reinstalling, ensure the bolt torque is appropriate, otherwise there might be abnormal noises while driving. Finally, clean any debris from the seat tracks to maintain smooth sliding.

[LeAliyah]

When removing the rear seats of my Haval H6, I discovered a handy tip: first adjust the headrest to its highest position to avoid obstruction. There are three key points to note when detaching the seat cushion: 1) Before lifting the seat, pry open the seam of the cushion to locate the fasteners; 2) When applying upward force, use your entire palm to distribute pressure evenly to prevent damaging the fasteners with concentrated force; 3) There are two fixing hooks at the rear of the seat - removing the cushion requires a combined push-pull motion backward and upward. The bolts on either side of the backrest are quite concealed, so I recommend using a universal joint socket tool. It's advisable to wear gloves throughout the process for better grip and to protect your fingers from metal scratches. After reinstalling, be sure to test the seat's stability - it's only successful if there's no wobbling when shaken.