How to Remove the Rear Seats of a GL8?
3 Answers
Method for removing the rear seats of a Buick GL8: On both sides of the rear seat headrest, near the window area, there are pull handles. Pull these handles to detach the rear seats. Below is an introduction to the Buick GL8: 1. The engine model of the Buick GL8 is 6517. 2. The vehicle uses a 2.5L direct-injection naturally aspirated engine to replace the older 2.4/3.0L naturally aspirated engines. 3. Although the power of this 2.5L engine still falls short compared to the 3.0L version, it generally meets daily usage requirements. Additionally, with the adoption of direct injection and optimizations such as start-stop technology, the GL8's fuel consumption has seen significant improvement over the older models, with an overall reduction of 16%.
To remove the rear seats of a Buick GL8, I think it's best to proceed step by step and not rush. First, check the seat structure: the rear seats are usually split-designed, with locking mechanisms for both the backrest and the seat cushion. I recommend starting with the backrest—find a helper to hold the release handle or button on the back of the seat, and a gentle press should fold the backrest down. Then, slide the entire seat to the frontmost position to expose the fixing bolts underneath—usually two or three Phillips-head bolts. Use a properly sized Phillips screwdriver and wrench to loosen them, being careful not to apply too much force to avoid stripping the threads or damaging the interior. The seat can then be lifted out easily. The whole process takes about five minutes, but remember to wear gloves to prevent hand injuries. After removal, take the opportunity to clean any dust or grease residue from the tracks to ensure smoother operation. If you're working in a garage, lay down an old blanket to protect the floor.
Last month, I helped my neighbor remove the rear seats of his GL8 because he wanted to convert the car into a temporary camper. First, we located the release mechanism behind the seats: there was a small pull ring or button on each side, and pulling it caused the backrest to fold down. Then, we pushed the seats forward to their maximum position, where we could see two or three silver mounting screws underneath. A simple adjustable wrench from home was enough to remove the screws, and the seats came loose. However, since it was our first time doing this, we forgot to check if the sliding rails were fully unlocked, which caused a few minutes of frustration. I recommend clearing out any items in the car, especially clutter in the trunk, before attempting this. After removing the seats, the space did become much larger, and we tested moving furniture—it was very convenient. Simple tools are sufficient; complicated ones just add unnecessary hassle.