How to Remove the Rear Seat of the Nissan Sylphy Classic?
4 Answers
The method for removing the rear seat of the Nissan Sylphy Classic is as follows: 1. Reach under the seat cushion and forcefully lift the front part upward until the front hooks are released. This action needs to be performed once on both the left and right front sections; 2. After lifting the front part, insert your left hand under the side, push the seat cushion toward the backrest with your right hand, and while pushing it in slightly, use your left hand to lift the rear part. This action also needs to be performed once on both the left and right sides; 3. After removing the seat cushion, unscrew the three screws under the rear backrest, lift it upward, and the rear backrest can be removed.
Removing the rear seats of the Nissan Sunny Classic is actually quite simple. Last time I did it myself and finished in half an hour. First, locate the two clip positions near the rear floor mats, right beneath the seats. Gently pry open the plastic covers with a flat-head screwdriver—don't use too much force or they might crack. Then, grab the front edge of the seat with both hands and lift upward firmly! A 'click' sound means the clip has released. Note that the rear seats are divided into left and right sections, so you'll need to handle them separately. After removing the seat cushion, don't rush to pull it out—first disconnect the seat belt sensor connector, that small black plug. Once everything's done, check the trunk: the top of the rear seat back is still hooked in place, and you'll need to press the clip to fold it down. I recommend preparing a pry bar and gloves—even a woman can handle this alone. If you're doing it yourself, remember to note the clip positions for reassembly, as they need to align with the guide rails.
I've removed the rear seats of the Nissan Sylphy several times. First, you need to locate the correct clips - there's a silver metal clip on each side near the doors under the rear seat. Use a pry bar to push the latch tongue and lift firmly upward, and the front part of the cushion will pop out. Don't yank it forcefully at this point, as there are wiring harnesses connected to the tire pressure monitoring sensors underneath the seat - you must disconnect the plug first before complete removal. The backrest is even easier - open the trunk and find the two release handles behind the rear headrests, pull them outward simultaneously to unlock. The most crucial part of the whole process is not to overlook the sensor wiring - last time my friend forced it and broke the harness, costing over 200 yuan in repairs. Actually, there are screwdriver tools hidden in the spare tire compartment - the manufacturer has prepared everything for you.
The removal of the rear seats of the Sylphy is divided into two parts: the seat cushion and the backrest. The seat cushion is secured by two metal clips located beneath the front seats. Feel for the raised parts with your hands and lift them upwards simultaneously on both sides. After removing the seat cushion, you will see a yellow connector, which is the seat belt sensor. To remove the backrest, you need to access the trunk. There are black pull rings on both sides at the top; pull them down simultaneously until you hear a click, indicating successful unlocking. Pay attention to three points throughout the process: disconnect the battery to prevent false airbag fault alerts, wear gloves to avoid scratching your arms, and ensure the clips are fully embedded into the tracks when reinstalling. The biggest concern when doing it yourself is the plastic clips breaking, so it's advisable to buy a few spare parts, which are very cheap. After removal, cleaning the carpet becomes particularly convenient. I do this every year when washing the car for the New Year.
