How to Remove the Rear Seat of a Volkswagen Santana?
2 Answers
The method for removing the rear seat of a Volkswagen Santana is as follows: Use a screwdriver to pry open the two clips at the front section of the rear seat, and then it can be removed. The dimensions of the Volkswagen Santana are: length 4282mm, width 1706mm, height 1489mm, with a wheelbase of 2603mm, and a body weight of 1155kg. The Volkswagen Santana is equipped with a 1.5L naturally aspirated engine, paired with a 6-speed AT transmission, delivering a maximum horsepower of 112PS, a maximum power of 82kW at 6100rpm, and a maximum torque of 145Nm at 4000rpm.
My experience in removing the rear seats of a Volkswagen Santana is to first locate the small pull ring at the bottom edge of the seat, usually at the junction between the backrest and the cushion. Pull it firmly to unlock the front part of the seat, then lift it up with both hands—don’t be too forceful to avoid breaking the clips. The backrest usually has fixing screws on the side of the trunk or behind the seat; once found, unscrew them with a regular wrench or screwdriver. The whole process takes no more than ten minutes, and just a wrench is enough. I did this to clean dust under the seats or install new cushions—it’s super practical. When reassembling, make sure the clips are aligned before pressing them down to avoid rattling. For older models, the steps are simpler; for newer ones, it’s best to refer to the manual in case of changes. I recommend clearing any clutter before disassembly—it creates more space for large luggage and makes daily maintenance much easier.
