How to Remove the Rear Seat of a Passat?
3 Answers
Passat rear seat removal steps are as follows: 1. First, lift the front part of the rear seat slightly. 2. Then push it backward until you hear a click sound. Steps to remove the backrest of the Passat are as follows: 1. There are three fixing screws at the bottom of the backrest, located near both sides and the middle. 2. Use tools to remove the locking screws, being careful not to remove the safety wire screws. After removing the screws, pull the backrest upward with force. Below is additional information: 1. The Passat interior maintains the Volkswagen style, with the air vents adopting a through-type design. The panoramic sunroof is the same as that on the Phideon, and the 8-way electrically adjustable perforated leather seats come with heating, ventilation, and massage functions. 2. In terms of assistance systems, it is equipped with adaptive headlights, blind spot monitoring, adaptive cruise control, lane keeping system, emergency rear braking, preventive occupant protection system, AEB brake assist, panoramic imaging, and MKE intelligent fatigue monitoring system.
I just removed the rear seat of my Passat and found it quite simple. It usually consists of two parts: the seat cushion and the backrest. For the seat cushion, crouch behind the rear seat, locate the small hook in the center at the front, grab it with your hand, and lift it upward slightly—the cushion will loosen, and you can gently remove it. The backrest is even easier. There’s a switch or pull ring at the bottom rear of the backrest; just flip or pull it to release the backrest. Be careful not to yank forcefully during the process to avoid damaging the plastic parts. After removal, cleaning dust from the carpet is very convenient. I also regularly check if the clips are aging, as periodic maintenance can extend the seat’s lifespan. Remember to park on level ground when doing this to prevent accidental sliding. With a few more practices, you’ll get the hang of it.
Removing the Passat rear seats is actually quite straightforward! The front edge of the seat cushion hides the release mechanism—just bend down to locate the small lever or hook underneath, then gently pull backward or lift upward to pop the cushion free. For the backrest, press the button in the seat gap to fold it down. Some model years might require a bit of finesse—avoid excessive force to prevent damaging components. After removal, I always take the chance to inspect seat belts and wiring harnesses for any issues. Reinstallation is as simple as aligning and snapping the parts back into place, almost like assembling building blocks.