How to Remove the Rear Seat Cushion of the Fit?
4 Answers
Method for removing the rear seat cushion of the Fit: There are two screws in the middle of the rear seat. Remove these two screws, then detach the two clips to take off the rear seat. The Fit is equipped with a 1.5-liter naturally aspirated engine, with the model code L15B3, delivering a maximum power of 96 kW and a maximum torque of 155 Nm. The Fit is a compact car under Honda, with body dimensions of 4109 mm in length, 1694 mm in width, and 1537 mm in height, and a wheelbase of 2530 mm. The front suspension of the Fit uses a MacPherson strut independent suspension, while the rear suspension employs a torsion beam non-independent suspension.
Last time I removed the rear seat cushion of my Fit by myself and found it wasn't too difficult but a bit tricky. First, clear all items from the rear seat, like toys or clutter, to avoid obstruction. Then crouch down to check the bottom of the cushion—there are usually one or two large clips or hooks securing it. You'll need both hands or a friend's help: one hand stabilizes the edge of the cushion while the other pulls upward firmly and steadily. Avoid slow wiggling, as the clips may loosen or bend. After removal, if you're cleaning or replacing the seat cover, handle it gently to avoid damaging the clip slots. When reinstalling, align and press down firmly. Remember, never attempt this with the engine running—turn it off for safety. My first attempt took over 20 minutes, but it gets easier with practice.
I often remove the rear seat cushions of the Fit, and the basic steps are as follows: First, clear the rear seats and identify the number of clip points under the cushions. Then, use your hands to pull upwards sharply from the front or side of the cushion—it should come off with one tug. Be mindful of the force applied; don’t pull too hard to avoid breaking the hooks, nor too lightly, as this might only partially dislodge the cushion. For older models, the clips might be tighter, so wearing gloves is recommended to protect your hands. Once removed, dry cleaning or installing new covers becomes easy. When reinstalling, simply press the cushion back into its original position until you hear a click. The entire process usually takes just three to five minutes. Remember to work on level ground, not on a slope.
Safe operation for removing rear seat cushions: Choose a quiet parking lot, turn off the engine, lock the car, and then proceed. Clear any clutter in the rear to avoid tripping. The seat cushion has plastic clips underneath—simply pull upwards with both hands. However, prevent children from touching things randomly nearby, as falling clips may cause injury. Clean or store the cushion properly after removal to avoid deformation from bouncing around in the car. Avoid doing this outdoors on rainy days to prevent slipping. The whole process is quick and simple—always prioritize personal and vehicle safety.
