How to Remove the Rear Headrests of a Cadillac XT5?
3 Answers
The method to remove the rear headrests of a Cadillac XT5 is as follows: 1. Press the plastic button below the headrest support rods with your hand; 2. Move the headrest support rods up and down; 3. While holding the adjustment button, lift the headrest upwards to separate the support rods from the seat, thus removing the headrest. The Cadillac XT5 has a body length, width, and height of 4813mm, 1903mm, and 1682mm respectively, with a wheelbase of 2857mm and a fuel tank capacity of 73 liters. The front suspension of the Cadillac XT5 is a MacPherson independent suspension, and the rear suspension is a five-link independent suspension. It is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 237PS, a maximum power of 174kW, and a maximum torque of 350Nm, paired with a 9-speed automatic manual transmission.
I remember the method for removing the rear headrests on the Cadillac XT5 is quite simple. There are usually two headrests in the rear, one on each side. Locate the metal rods of the headrest, and near the top, there’s a small button or latch. Press that button and slowly pull the headrest upward. Don’t use too much force, as the rods might be stuck; if it’s too tight, try gently wiggling it a bit before pulling. After removal, I recommend placing it in the trunk or securing it to the seatback to prevent it from rolling around and getting lost. The same method applies when reinstalling—simply align the rods with the seat holes and press down to lock them in place. This is a common operation, especially useful when you need to load large luggage or clean the seats. The headrest design is quite user-friendly and easy to handle. By the way, other Cadillac models like the XT6 are similar, with the button position remaining largely unchanged.
When handling car headrests, safety is paramount; the method to remove the rear headrests of a Cadillac XT5 is quite straightforward. First, turn off the engine and ensure the car is parked on level ground. Then, enter the rear seats and locate a small button on the upper part of the headrest posts. You need to press and hold this button while gently pulling the headrest upward. Avoid using excessive force, as this could damage the posts or the internal structure of the seat. Personally, I always wear gloves to protect my fingers, as the button can sometimes be sharp. The removed headrest should be stored in the trunk or under the seat to avoid obstructing visibility. If you encounter difficulty, dust might be clogging the button—cleaning it before trying again usually helps. This design is common in SUVs to facilitate passenger space adjustment. When reinstalling, press the headrest all the way down until you hear a click, ensuring it’s securely in place to prevent safety hazards. For maintenance, occasional lubrication of the button can extend its lifespan.
