How to Remove the Rear Axle Shaft of Wuling Sunshine?
2 Answers
Use a lift to raise the vehicle, remove the front wheels, detach the locking tab on the spindle nut, and then remove the nut. Drain the transmission fluid, replace it with a new sealing gasket, and then reinstall the transmission drain bolt. Remove the lock pin and castellated nut, separate the ball joint from the steering knuckle, pull the steering knuckle outward, and use a plastic hammer to detach the outer CV joint from the front wheel hub. Use a pry bar to remove the inner CV joint from the differential, then use a punch and hammer to pry the inner CV joint of the right axle shaft from the differential, and finally remove the right axle shaft. Remove the retaining ring from the inner CV joint of the left axle shaft, then remove the retaining ring from the intermediate shaft. The disassembly is now complete.
To remove the rear axle shaft of the Wuling Rongguang, as someone who frequently works on cars, I would start by lifting the vehicle. Find a flat surface and use a jack to securely lift the rear wheel section, placing safety stands to prevent it from dropping. Next, remove the rear tire to expose the wheel hub nut area. Use a socket wrench to loosen the large nut on the axle shaft head—it’s usually very tight, so applying some rust penetrant can help. Then, carefully remove the brake system components without forcing them, taking care to protect the wiring. Locate the differential connection end, loosen the mounting bolts, and gently pull out the axle shaft. Check for any retaining rings—if present, use a specialized snap ring plier to remove them. Ensure you have the right tools: sockets, a torque wrench, and gloves. Take your time to avoid damaging bearings or seals. After removal, inspect the axle shaft for wear; replace it immediately if cracks are found. Regular maintenance can extend its lifespan. The process is straightforward, but safety is paramount—it should take about 20 minutes to complete.
