How to Remove the Radio in Changan Yuexiang V3?
3 Answers
Pull the air conditioning vent above towards yourself to see the fixing screws. First remove the frame, and there are two screws underneath that you can feel with your hand. After removing the frame, you can see the screws on both sides of the radio. Remove these screws to pull out the radio.
Disassembling the Changan Alsvin V3 radio, I've experienced it a few times during repairs. First, you need to prepare tools like a small Phillips screwdriver and a set of plastic pry bars to prevent scratching the interior trim. Then, sit in the driver's seat and carefully observe the panel structure around the radio, usually covered by a plastic bezel. Gently insert the pry bar at the lower right or left corner of the bezel, applying even force to pry it open—it's secured by clips, so avoid excessive force to prevent deformation, which would make reinstallation harder. After removing the bezel, the radio unit will be exposed. Locate the screw holes (typically 2-4) and loosen them with the screwdriver. A crucial step is disconnecting the vehicle's negative battery terminal first to avoid short-circuit risks. Then, carefully pull out the radio unit; there are wiring harness connectors at the back, each with unique shapes—press the clips and gently unplug them. The whole process takes 5-10 minutes, but proceed slowly to avoid rework. If you plan to upgrade the system, documenting cable order or taking photos for reference is a good habit to simplify installation.
When removing the Chang'an Yuexiang V3 radio, I referred to common car model experiences. Only basic tools are needed: a plastic pry tool and a screwdriver are sufficient. Start by prying the panel from the side of the dashboard—take your time and apply force gradually to avoid breaking the clips. After removing the panel, you'll see the radio's mounting screws; remove them in order. Disconnect the car battery in advance to ensure zero current and prevent risks. When pulling out the radio, pay attention to the rear connectors, as they often have small locking clips—press to release before unplugging the wires. The whole process is simple and takes about 15 minutes, but attention to detail is key—I tried a few times and found that rushing can lead to pulling the wrong wires, causing the radio not to start later. It's advisable to check if the radio's connectors are oxidized and clean them while you're at it to extend its lifespan. Remember to test after finishing to avoid wasted effort.
