How to Remove the Power Steering Pump of a Geely Emgrand?
3 Answers
Method for removing the power steering pump of a Geely Emgrand: Remove the power steering pump reservoir by pulling it off by hand; Use a tool to remove the spring clip at the bottom. There is a small hole under the housing; insert the tool into the hole and push firmly; After removing the spring clip, tap off the rear cover and remove the small retaining ring on the shaft; Once the retaining ring is removed, the pump shaft and pulley can be pulled out together; Remove the oil outlet screw and the internal pressure valve assembly in sequence. The Geely Emgrand is a compact car with a 4-door, 5-seat sedan body structure. Its dimensions are 4632mm in length, 1789mm in width, and 1470mm in height, with a wheelbase of 2650mm.
I previously disassembled the power steering pump on a Geely Emgrand. That time helping my neighbor fix his car was quite interesting. The whole process starts with safety first—absolutely must disconnect the battery negative terminal to prevent accidental short circuits, this is basic procedure. Then locate the power steering pump position; it's usually on the left side of the engine bay near the belt system, and Emgrand models are pretty much all like this. Loosen the belt tensioner pulley, use a wrench or socket tool to slowly remove the belt, then disconnect the oil pipe fitting—remember to have a container ready to catch any leaking oil, don’t let it drip on the ground. There are usually two or three bolts securing the pump, a 10mm socket will do the job. Be careful not to damage the bracket during removal; I encountered rusty bolts that time and had to use penetrating oil to loosen them. After removal, check if the pump wheel rotates smoothly—if there’s noise, it’s time for a new part. The whole process takes about 30 minutes; beginners should wear protective goggles to guard against splashes. When reinstalling, ensure the seal ring is aligned and add new oil, and take the opportunity to clean any oil stains to keep the engine bay tidy.
When I first started tinkering with car repairs, I was quite nervous removing the power steering pump. For a Geely Emgrand, beginners should start with simple steps: prepare gloves and rags. Ensure the car is turned off, and disconnecting the battery is top priority to avoid sparks. The power steering pump is located on the left side of the engine bay. When loosening the belt tensioner, apply even force to prevent the belt from getting tangled. At first, I forgot to connect the oil pipe and spilled oil everywhere, regretting not placing a container. Use a wrench to remove bolts; if there's rust, apply some lubricant to loosen it. Handle pipe connections carefully to avoid damage. After removing the pump, check the mounting holes for wear and replace if necessary for convenience. Don’t rush the process; it’s normal for beginners to take about 40 minutes. The key is safety—avoid injuring your hands.
