How to Remove the Position Light of Lavida?
3 Answers
To remove the position light of Lavida, follow these steps: 1. Lift and pull out the white plastic bolt at the rear of the headlight to remove the headlight. 2. Pay attention to the wiring harness at the rear of the headlight. There's no need to disconnect it for replacing the position light. Just remove the rubber rear cover of the headlight. 3. The position light is located within the red circle. Use needle-nose pliers to pull it out and replace it with a new one. If the position light is installed in reverse, it won't light up and will trigger a light warning. Reassemble in the reverse order of disassembly. Here is more information about Lavida: 1. It is equipped with two powertrains: a 1.5L naturally aspirated engine and a 1.4T turbocharged engine. 2. The 1.5L model is paired with a 5-speed manual or a 6-speed automatic transmission, while the 1.4T engine is matched with a 7-speed dual-clutch transmission. 3. If you prioritize the stability of the powertrain, the 1.5L model is recommended. For a better driving experience, the 1.4T is undoubtedly superior.
I've been driving my Lavida for several years and have replaced the parking lights multiple times. The basic steps are straightforward: first, turn off the engine and remove the key to ensure safety by cutting off the power. Open the hood and locate the headlight assembly—the parking light is usually tucked in a corner. Some models require removing a fixing screw or clip—last time, a small Phillips screwdriver was enough. The bumper might be slightly in the way, but you only need to create a little space without fully removing it. Then, gently pull out the lamp holder and twist the bulb counterclockwise. For installation, reverse the steps, ensuring you use the correct bulb size (T10 is common for Lavida). A tip: wear gloves to avoid scratches, and test the light after replacement. If bulbs burn out frequently, it might be a voltage or wiring issue—check the fuse box while you're at it. The whole process is quick and cost-effective—DIY takes about 20 minutes, saving you money compared to a shop visit.
When I first started driving, I was quite nervous about removing the side marker lights, but following the guide step by step made it manageable. First, turn off the engine, remove the key, and open the hood for better lighting. The side marker lights are tucked inside the headlight assembly—not too deep—so locate them using the manual diagram or search online for a Lavida video tutorial. You might encounter clips or small screws during removal; use tools to gently loosen them without forcing. Then, carefully pull out the lamp socket, twist the bulb to remove it, and avoid touching the filament. Before installing the new bulb, match the original model (e.g., T10) and reverse the steps to secure it. Precautions: Keep a flashlight handy to illuminate details, and handle wires gently to avoid damage. After completion, always close the hood and test the switch. Related tips: Side marker lights often fail due to aging or water ingress—cleaning the lens can improve brightness. These small lights are crucial for nighttime driving safety, so regular maintenance ensures peace of mind. Learning basic DIY skills like this pays off in the long run.
