How to remove the license plate light of Chery A3?
3 Answers
Method for removing the license plate light of Chery A3: First, open the rear trunk and remove the protective panel. Inside the protective panel, there are fixing screws for the license plate light. After removing them, take off the license plate light cover from the outside of the license plate light. Then, rotate the license plate light counterclockwise behind the wiring harness to remove it, replace the bulb, and reinstall in reverse order. Description and function of the license plate light: 1. According to relevant regulations, all vehicles must turn on the license plate light at the rear when driving at night. The brightness of the rear license plate light must be sufficient for a person with normal vision to clearly see the license plate number within 20 meters at night. 2. Every vehicle has a license plate in a conspicuous position at the front and rear, and next to each license plate is a license plate light. During the day, the license plate number is clearly visible. At night, without the illumination of the light, the license plate number cannot be seen clearly. 3. The national traffic laws and vehicle operation safety regulations specify the configuration and installation methods of vehicle lights, and the regulations on vehicle license plate lights are an important part of them. 4. At night, the license plate number can be clearly seen through the light of the license plate light, and the vehicle's data can be checked through the number. In the event of a traffic accident, traffic police can see the vehicle's license plate number from the front or rear of the car and find the responsible party through the license plate number.
The license plate light on my Chery A3 is broken, and it's quite simple to replace the bulb by myself. First, open the trunk lid, and you'll see a license plate light cover, usually located above the license plate. Second, carefully pry open the edge of the light cover with a small flat-head screwdriver, but don't use too much force to avoid cracking the plastic. Third, after removing the cover, you'll see the bulb connected to a wiring socket; gently pull out the plug by pressing the clip part to avoid breaking the wires. Fourth, replace it with a new T10 LED or halogen bulb and reinstall it in reverse order. Clean the bulb socket before installation to prevent poor contact. The whole process takes about ten minutes. Remember to turn off the power by removing the car key first to prevent short circuits. All you need is a screwdriver, and having a flashlight in the trunk for lighting makes it more convenient. Be patient during disassembly and installation to avoid scratching the paint. Doing it yourself can save you about a hundred bucks in repair fees, but if the socket is severely corroded, it's better to have a professional take a look.
Removing the Chery A3 license plate light requires a step-by-step approach. Last time I did it, I learned the key is not to use excessive force. After locating the license plate light area in the trunk, you'll find the lens is secured by clips, not screws. Use a flathead screwdriver to gently pry open the clips, taking care not to rush. Before unplugging the bulb connector, ensure the vehicle is turned off and the power is disconnected to avoid electrical spark hazards. If the bulb appears blackened due to aging, it might be caused by water ingress or contact point oxidation—replace the bulb and check if the sealing ring is intact to block moisture. Basic tools like a regular screwdriver and gloves (for better grip) are sufficient. During the process, be cautious not to damage the trunk wiring harness. If the lens gets stuck, don't force it—apply some WD-40 lubricant and try again. After removal, take the opportunity to wipe away accumulated dust in the trunk to maintain cleanliness and prolong component lifespan. The entire process takes under 15 minutes—simple and time-saving.
