How to Remove the Honda Lingpai Center Console?
4 Answers
The method for removing the Honda Lingpai center console is as follows: 1. Remove the ashtray; 2. Remove the CD disc storage box below the CD player; 3. Locate and remove the two 4mm bolts underneath the CD player. The Honda Lingpai is a compact 4-door, 5-seater sedan with dimensions of 4756mm in length, 1804mm in width, and 1509mm in height, with a wheelbase of 2730mm and a fuel tank capacity of 40 liters. The Honda Lingpai is equipped with a 1.5L engine, with a maximum power speed of 6000 rpm and a maximum torque speed of 5000 rpm. It adopts a front-engine, front-wheel-drive layout, with MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.
Last month, I personally disassembled the Honda Lingpai's center console. The steps were quite simple but required careful attention. First, locate the plastic cover on the side of the center console from the driver's seat, and gently pry it open with your hands or a plastic pry tool—avoid using excessive force to prevent scratches. Inside, you'll find several Phillips-head screws; use an appropriate screwdriver to remove them. After opening, slowly lift the center console cover, being mindful of the connected air conditioning controls and radio wiring harness below. Disconnect each connector one by one, and avoid pulling forcefully to prevent damaging the ports. The entire process takes about half an hour, requiring only basic wrenches and pry tools. I did this to install a USB charging port, and the result was good, but I recommend beginners prepare spare clips in case any break during the process. For safety, remember to turn off the engine and disconnect the battery's negative terminal to prevent accidental short circuits. When reassembling, align the positions and screw holes properly—it's not difficult but requires some patience.
When I attempted to dismantle the Lingpai center console for the first time as a beginner, I was quite nervous. After opening the glove box, I discovered hidden mounting screws and slowly loosened them with household tools, but nearly scratched the panel. When removing the panel, the wire connectors required careful handling—I had to make sure not to confuse the air conditioning and audio interfaces. I recommend searching for model-specific tutorials or videos online to avoid making silly mistakes like I did, which damaged a few plastic parts. The empty space left after removal can be used for cleaning or modifications, but if you lack the proper tools, it's best not to force it—professional auto shops can save a lot of hassle. The whole process taught me patience: tackling one small section at a time and accumulating experience is what matters most.
I've done the center console removal once on my Honda Lingpai. That time, a friend helped me replace the cabin air filter. We started by prying open the top cover of the dashboard with plastic tools, gently pushing it upwards. The screws were located under the armrest and near the cigarette lighter - after removing those, the cover lifted right off. All connectors were clearly labeled, so we just disconnected them in order. Felt quite accomplished afterwards, but during reassembly you must align all clips properly to prevent loose connections. Beginners can practice with this procedure first.
