How to Remove the Honda Fit Trunk Door Panel?

Can Alcohol Be Sprayed on Cars for Disinfection?

Alcohol can be sprayed on cars for disinfection. Alcohol has disinfecting and sterilizing properties, but using it for wiping instead of direct spraying is preferable. Before disinfecting with 75% alcohol, the car should be turned off and kept in a non-operational state while ensuring proper ventilation. Avoid contact with open flames to prevent explosions. Here are some relevant details: 1. To achieve disinfecting and sterilizing effects, 75% medical-grade alcohol should be used. Lower concentrations may not be effective. 2. Alcohol molecules have strong permeability, allowing them to penetrate bacterial membranes, enter the bacteria's interior, coagulate the proteins essential for bacterial life, and kill the bacteria. When alcohol concentration exceeds 70%, its evaporation increases the flammable gas content in the car's air. Even a small spark could trigger an explosion. 3. Additionally, since car interiors often feature leather and plastic materials, high-concentration alcohol may corrode these surfaces. Therefore, after disinfecting with alcohol, ensure frequent ventilation and wait for it to evaporate before starting the car.

4

1

Share

How to Determine the Condition of a Motor Using a Multimeter?

Using a multimeter to test the condition of a motor involves the following steps: With the power disconnected, place the black and red probes of the multimeter on the motor's terminals to measure. For a three-phase motor, measure between each pair of terminals and observe the resistance value on the multimeter. If the digital multimeter displays a value, or the analog multimeter shows resistance, it indicates that the motor windings are conducting properly. If no resistance is detected, the motor is likely damaged. Additional Information: The cause of motor overload may be low terminal voltage. This refers to the voltage measured at the motor's stator terminals during startup or full-load operation, not the no-load voltage. When the motor load is constant, a decrease in voltage will inevitably lead to an increase in current, causing the motor to overheat. Severe voltage drops can force the motor to stop or operate at low speeds, with a sharp increase in current potentially leading to motor burnout.

3

1

Share

What causes the flickering when replacing LED bulbs in Volkswagen?

Volkswagen replacing LED bulbs with flickering when powered on is likely due to induced electricity, as many wires are bundled together in sleeves or placed closely. When one wire is energized, others generate induced electricity, and LEDs can illuminate with very small currents. It is recommended to retrofit xenon lights with bi-xenon projectors to achieve the original xenon mode, which is the optimal solution. Below is relevant information about automotive headlights: 1. The power of original headlights is generally around 55w, with an operating current of approximately 4.5A, while LED lights typically have a power of only 20w-25w. The starting current generally requires 4A-8A for normal startup, and after successful startup, the operating current is only around 1.5-3A. At this point, the vehicle's computer will detect abnormal current. 2. Some vehicles alert through the dashboard, while others automatically shut off. After shutting off, because the vehicle's power switch is already on, the vehicle will relight the bulbs, resulting in the phenomenon of continuous flickering of the vehicle's lights. This situation requires the use of ballasts or decoders.

11

4

Share

Why is the Civic Type R not introduced?

Civic Type R is not introduced because Honda Motor is still in a wait-and-see attitude towards China's unclear new energy credit policy and dares not rashly introduce these high-performance cars that are not environmentally friendly. Here are the relevant details: 1. The Civic Type R is a high-performance car launched by Honda Motor. It adopts a sedan body design, but the engine and configuration used in this car are quite impressive. 2. As a high-performance model, in terms of power, this car is equipped with a high-performance version of a 2.0T turbocharged engine. The maximum power of this engine is 320 horsepower, and the maximum torque is 400 Nm. In terms of the transmission system, it is matched with a 6-speed manual transmission. 3. The reason for not using an automatic transmission and opting for a manual one is to better experience the driving pleasure of this car. 4. It is worth mentioning that, as a high-performance sports car, this car adopts a front-wheel-drive mode, which is relatively rare among many high-performance models. 5. Although the overall design of the Civic Type R is very similar to the regular Civic, its performance in details is completely different. The new carbon fiber body and the red Honda emblem better highlight the sporty temperament of this car.

18

0

Share

What is the fuel consumption of the Mitsubishi ASX?

Mitsubishi ASX 1.6L manual: Combined fuel consumption: 6.0L/100Km, average user-reported fuel consumption: 7.4L/100Km. Mitsubishi ASX 2.0L manual: Combined fuel consumption: 7.0L/100Km, average user-reported fuel consumption: 8.2L/100Km. Mitsubishi ASX 2.0L CVT continuously variable transmission: Combined fuel consumption: 7.0L/100Km, average user-reported fuel consumption: 9.0L/100Km. Relevant information about vehicle fuel consumption is as follows: 1. Different driving habits, road conditions, traffic congestion, load, fuel quality, use of air conditioning/heating, whether the car is in the break-in period or an older vehicle, etc., will result in different fuel consumption. Generally, combined fuel consumption is around 8-10L/100Km. 2. The Ministry of Industry and Information Technology (MIIT) fuel consumption figures have a certain deviation from the actual fuel consumption reported by drivers, usually being 1-2L/100Km lower than the average fuel consumption reported by car owners. This is because the MIIT measures vehicle fuel consumption under specific environmental and conditional settings, which differ significantly from real-world driving scenarios. Therefore, the fuel consumption measured under these more "ideal" conditions is inevitably lower.

14

5

Share

Can I Get My License Directly After Passing Subject 4?

After passing Subject 4, you can receive your license on-site, usually within about 2 hours. Subject 4, also known as the Subject 4 theory test or driver's theory test, is part of the motor vehicle driver's license examination. The main content includes: requirements for safe and civilized driving operations, knowledge of safe driving under adverse weather and complex road conditions, emergency handling methods for situations like tire blowouts, and knowledge of post-traffic accident procedures. The Subject 4 test consists of 50 questions, primarily in the form of case studies, images, and animations, with a full score of 100 points and a passing score of 90. After the implementation of the Ministry of Public Security's Order No. 123, the Subject 3 test was divided into two parts: in addition to the road test, a safety and common sense test was added, commonly referred to as 'Subject 4,' which assesses 'driving ethics.' Because this test is conducted after Subject 3, it is commonly referred to as the Subject 4 test. Officially, there is no Subject 4. Before the test, students can study traffic regulations through driver's mock test software on mobile devices or computers.

9

2

Share

How to Remove the Honda Fit Trunk Door Panel?

Can Alcohol Be Sprayed on Cars for Disinfection?

How to Determine the Condition of a Motor Using a Multimeter?

What causes the flickering when replacing LED bulbs in Volkswagen?

Why is the Civic Type R not introduced?

What is the fuel consumption of the Mitsubishi ASX?

Can I Get My License Directly After Passing Subject 4?

What is the fuel consumption of the Pajero V97?

What is the weight of car fire extinguishers?

What automatic transmission is used in the Buick GL8?

What is the fuel consumption of the Toyota Corolla hybrid model?