How to Remove the Headlights of the New Fit?
3 Answers
You should locate a cover behind the headlight, twist it open to reveal the bulb, and then unscrew the bulb from its mounting clip with your fingers to successfully remove the headlight. Car headlights, also known as LED daytime running lights, are not only related to the appearance of the vehicle but also closely linked to safe driving at night or under adverse weather conditions. Below are the precautions for removing the headlights of the new Fit: 1. Wear gloves throughout the entire replacement process; after removing the bulb, avoid touching the glass of the bulb directly with your hands. 2. It is not necessary to choose the original bulb brand when purchasing; as long as it meets the national 3C certification standards, it can be used. 3. Before starting the replacement, ensure the vehicle is turned off, the key is removed, and wait for the engine to cool down completely. 4. Make sure the voltage and wattage of the bulb are the same as the original car's. Do not believe merchants who claim that increasing wattage will increase brightness, as this can cause unstable current and lead to short circuits. The method for removing the headlight bulb of the new Fit is as follows: First, turn off the vehicle for more than 5 minutes, remove the key, and wait for the engine to cool down completely. Then, open the engine compartment cover to avoid burning any parts.
I've done the job of removing the new Fit's headlights a few times myself, and it's quite simple. First, you need to prepare the tools—a Phillips screwdriver is a must, and you might also need a small wrench. After opening the hood, locate the back of the headlight assembly, where there are usually securing screws. Loosening those screws will allow you to remove the headlight unit. Remember to gently push the clip when unplugging the electrical connector—don’t yank it hard to avoid damaging the port. The whole process takes no more than 15 minutes, making it suitable for DIY enthusiasts. Having the right tools is key—I keep a small toolbox handy for such tasks. After removal, check if the lamp socket is clean; if there’s dirt, wipe it down to ensure a secure fit when reinstalling. Beginners might find it tricky at first, but once you try it, you’ll get the hang of it.
Be extremely careful when removing headlights! Especially for new cars with electronic components, the first step is to disconnect the negative terminal of the battery to prevent short-circuit risks. Wear gloves to protect your hands. In terms of tools, a screwdriver and gloves are sufficient. Open the engine hood, locate the rear position of the headlight assembly, remove 2-3 fixing screws, and gently pull out the headlight while unplugging the wire connector. Handle with care to avoid scratching the paint or damaging surrounding parts. After completion, check the circuit to ensure it's intact and prevent future malfunctions. I also recommend working in good lighting conditions to avoid mistakes and rework. Safety first—take your time and you'll get it done.
