How to Remove the H6 Rearview Mirror Housing?

1 Answers
VanConnor
07/30/25 4:41am
The method for removing the H6 rearview mirror housing: 1. Prepare the necessary tools for removal, including a flathead screwdriver. First, use the flathead screwdriver to pry open a gap along the edge between the mirror housing and the mirror base. 2. Similarly, take out the flathead screwdriver again and insert it into the gap between the right side of the mirror and the housing to release the internal clips. Once both clips are released, proceed slowly and steadily. Gently pull outward by hand, and the mirror housing will come off. The H6 measures 4653mm in length, 1886mm in width, and 1730mm in height, with a wheelbase of 2738mm. It is a 5-door, 5-seat SUV equipped with a 7-speed dual-clutch transmission.
Was this review help?
17
5
Share
More Forum Discussions

What are the reasons for a diesel vehicle being difficult to start but running normally after starting?

There are four main reasons why a diesel vehicle may be difficult to start. Below are the explanations for the causes of difficult starting in diesel vehicles: 1. Air or moisture in the fuel system: If the fuel pipe connections are loose or the inlet pipe is worn and damaged, air can enter the fuel system. Additionally, diesel fuel contains a certain amount of moisture. When there is too much air or moisture, it can affect the normal starting of the diesel engine. 2. No fuel in the tank, the inlet valve is closed, or the tank vent is blocked: Some drivers fail to monitor the diesel level in the tank, and after the fuel is exhausted, they do not refill it in time. Alternatively, the fuel inlet valve may have been manually closed. It is also possible that the tank vent has become clogged with dust or debris due to prolonged use. When the vent is blocked, the tank cannot properly equalize pressure with the atmosphere, creating a vacuum in the upper part of the tank as the fuel level drops. This affects fuel supply and may even interrupt it entirely. 3. Clogged fuel pipes or diesel filter: Fuel pipes may become misaligned or the filter screens in the pipe connections may become clogged due to lack of cleaning over time. If the fuel pipes are deformed or the diesel filter element is clogged with impurities, the pipes or filter element must be replaced or cleaned promptly. Otherwise, the clogging can make it difficult to start the diesel engine. 4. Severe wear of the injection pump plunger or delivery valve, leading to poor sealing: This can reduce the fuel injection pressure, causing delayed injection and incomplete fuel combustion, ultimately making the diesel engine difficult to start.
13
5
Share

What is the introduction of Audi's gear positions?

Audi automatic transmission gear positions are introduced as follows: P gear: P——Parking gear, after the car stops, engaging the P gear will brake the vehicle to prevent movement. Currently, some models have an independent P gear, referred to as electronic braking. R gear: R——Reverse gear, this gear can only be engaged when the vehicle is stationary. Models with a lock button require pressing the button to switch. N gear: N——Neutral gear, temporarily stop and engage this gear, such as when waiting at a traffic light, and the handbrake should be pulled up at the same time. This gear is prohibited when going downhill. S gear: S——Sport gear, the difference between D gear and S gear is only that the computer switches different shifting programs, so the S gear can be switched at any time without adverse effects such as damaging the transmission. It is suitable for overtaking but not for high-speed use.
14
0
Share

Can Tesla Add Autonomous Driving Later?

Yes, it can be added, but Tesla's Full Self-Driving (FSD) is not necessary to add at present. Currently, Tesla's camera performance has significant limitations and is not sufficiently safe. Moreover, artificial intelligence technology itself is not yet mature, and the improvements in performance are very limited at this stage. Autonomous driving is a system with extremely high safety requirements; it does not allow any failures, and there must be redundant systems in place to ensure safety in case of a failure. Here is some additional information: Introduction to Tesla's Autonomous Driving: Currently, Tesla offers autonomous driving, not fully unmanned driving. The car can detect obstacles on the road, automatically maintain the lane, control acceleration and deceleration in following traffic, and steer automatically based on lane markings (including lane changes). After activating AP (Autopilot), the car controls the steering wheel, brakes, and throttle automatically. It can recognize current lane markings and speed limits. If there is a car ahead, it will automatically control the distance (which can be adjusted for longer distances). When there is no car ahead, the car will accelerate to the maximum speed limit or the speed set by the driver.
10
4
Share

Where is the sunroof drain outlet of the Audi A3?

The sunroof drain outlet of the Audi A3 is located at the corners of the sunroof. Here are the specific details about the Audi A3: Body dimensions: The Audi A3 is a compact sedan under the Audi brand, available in both hatchback and sedan versions. The hatchback version measures 4343 mm in length, 1815 mm in width, and 1458 mm in height, with a wheelbase of 2630 mm. The sedan version measures 4554 mm in length, 1814 mm in width, and 1429 mm in height, with a wheelbase of 2680 mm. Powertrain configuration: This car is equipped with a 1.4-liter turbocharged engine. The engine delivers a maximum power of 110 kW, a maximum torque of 250 Nm, with the maximum power achieved at 5000 to 6000 rpm and the maximum torque available from 1750 to 3000 rpm.
18
2
Share

At What RPM Should You Shift Gears in a Car?

Generally, the shifting RPM can be chosen between 1500-2500 rpm. If you aim for fuel economy, you can shift around 1500-1800 rpm, with lower gears appropriately increased to around 2000 rpm. During the break-in period, it's best to lower the shifting RPM. If you want better performance, you can shift around 2000-2500 rpm. Precautions are as follows: 1. Do not coast in neutral: Remember to engage the handbrake and shift to P before turning off the engine. Whether in low gear, manual mode, or sport mode, it's best not to overcomplicate things—just use D gear normally during regular driving. 2. Manual transmission cars should start smoothly: When starting, control the clutch and throttle properly. Lift the clutch halfway (until you faintly feel the vehicle vibrate), then lightly press the throttle. At this point, simultaneously release the handbrake or brake and slowly lift the clutch. Once the vehicle starts moving slowly, drive for a while before shifting to second gear, again quickly pressing and slowly lifting the clutch.
14
4
Share

What is the history of Honda Civic?

Honda Civic's history is introduced as follows: 1. Birth: CIVIC is Honda's legendary model, born in 1972, and has undergone ten generations of innovation and evolution over the past 47 years, gaining recognition and trust from 25 million users worldwide. From its inception, CIVIC has represented Honda's spirit of continuous challenge and breakthrough, being Honda's most core soul model. Whether it was the first generation in 1972 with the CVCC engine breaking through the limitations of the "Musky Act," the sixth generation in 1995 equipped with the B16B, or the fastest front-wheel-drive new Type R in 2015 dominating the Nürburgring, CIVIC has always been at the forefront of the times, shining as the brightest star in the night sky. 2. Entry into China: Since the eighth-generation CIVIC entered China in 2006, after 15 years of cultivation, it has won the favor of 1.8 million Chinese users. As the iconic model marking Dongfeng Honda's transition from the product era to the brand era, the tenth-generation CIVIC (Civic) perfectly embodies the brand spirit of "Stay ahead," becoming Honda's first model in China to achieve annual sales exceeding 200,000 units in 20 years.
12
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.