How to Remove the Fit's Trunk Door?
4 Answers
To remove the trunk door of a Fit, first open the car trunk and take off the interior trim panel. Below is a detailed introduction about the Fit's trunk door: 1. Use tools to remove the clips and screws inside the trunk: Professional tools are required for the removal of the trunk door, and it is recommended to have it done at a professional auto repair shop. 2. The elastic net in the car trunk can be used to secure fragile items: Every car trunk is equipped with an elastic net. If there are fewer items in the trunk, fragile items may roll around, and at this time, the elastic net can be used to secure them. 3. The trunk partition can create a relatively hidden space in the trunk: The space created by the trunk partition is very practical, making it more convenient to handle work and other matters.
As someone who enjoys DIY car repairs, I've taken apart the Fit's tailgate several times and found it quite straightforward. All you need is a Phillips screwdriver and a 10mm wrench—having a friend to help hold the door is ideal to prevent it from falling and causing injury. First, open the trunk and remove the interior trim panel: locate the screw holes, unscrew them with the screwdriver, then carefully pry off or remove the plastic clips by hand—avoid using excessive force to prevent breakage. Once the trim panel is off, you'll see the wiring harness connectors; disconnect all wires slowly but be sure to label their positions or take photos for reference to avoid incorrect reassembly. Next, use the wrench to loosen the hinge bolts at the top of the tailgate—usually there are two. After loosening, have your friend steady the door as you gently remove it. Once done, you can repair the latch or replace parts. Throughout the process, wear gloves to protect your hands, as clips and metal edges may cause cuts. From start to finish, take your time—it should take about 20 minutes. After reassembly, test the taillights and door switch to ensure everything works properly.
In my career as a mechanic, removing the Fit's tailgate is considered basic work. Remember the key steps to avoid common mistakes. First, ensure the car is parked on level ground and turned off—a Phillips screwdriver is all you need for tools. The main focus is handling the interior trim panel: the plastic clips are fragile, so pry them off one by one patiently without using excessive force to avoid breakage. Before disconnecting the wiring harness connectors, take photos to document their original positions to prevent misconnection and malfunctions. When loosening the hinge bolts, don't remove them completely—loosen them halfway first and have someone support the door's weight. Once done, fully remove them. Throughout the process, be careful not to scratch the car's paint, a detail many beginners overlook. After repairs, reinstall everything, align the seams properly before tightening the bolts, and finally check all functions. I recommend regularly inspecting the wiring harness's waterproof seals for aging to prevent leaks and rust.
As a regular car owner, I was a bit nervous about removing the Fit's tailgate for the first time, but found it straightforward with care. Prepare a Phillips screwdriver, open the trunk, then remove the interior panel screws and clips. Next, disconnect the wiring and mark their positions. Loosening the top bolts requires a helper to hold the door to prevent it from falling. Once done, reinstall the parts and test. It takes just 10 minutes, but safety first—don't do it alone.
