How to Remove the ETC Device from the Car?
2 Answers
Steps to remove the ETC device from the car: 1. Prepare a piece of fishing line. 2. Wear a pair of rubber gloves, such as those used for dishwashing or laundry. 3. Straighten the fishing line with both hands. Pull it forcefully downward from the top of the ETC device. If it is stuck too tightly, you may need to pull several times, then use the fishing line to cut through. 4. After cutting, use a wet wipe to clean any residue left on the windshield. Below is some related information: ETC (Electronic Toll Collection) is a non-stop toll collection system used on highways or bridges. It works through dedicated short-range communication between the vehicle-mounted electronic tag installed on the windshield and the microwave antenna in the ETC lane at the toll station. This system utilizes computer networking technology for backend settlement processing with banks, allowing vehicles to pass through highway or bridge toll stations without stopping while still paying the required fees.
Last year when I needed to replace my car, I decided to remove the ETC device from my old vehicle myself. First, I turned off the engine for safety, then used a hairdryer on medium heat to warm the ETC base for about 5 minutes to soften the adhesive—being careful not to overheat and damage the device. Next, I gently pried it loose from the edge using a credit card, taking care not to apply too much force to avoid cracking the windshield. After removal, any leftover adhesive on the glass was easily wiped away with alcohol wipes, saving me a trip to the repair shop. The whole process took about 10 minutes. I stored the ETC device in a cool place for reuse when I got my new car—just needed to reattach it and update the info with the service provider, which was straightforward. If the adhesive is too stubborn, try heating it a bit longer, but always prioritize safety over speed.
