How to Remove the Door Panel of the 10th Generation Accord?
2 Answers
The method for removing the door panel of the 10th Generation Accord: 1. First, remove the control panel with the wiring harness; 2. Remove the screws securing the door trim panel; 3. Take off the small decorative panel on the inner door trim; 4. Pry from the edge between the door panel and the inner door trim to separate them; 5. Remove the screws at the bottom of the door, use a screwdriver to pry open a gap, pull outward, and lift the door panel upward to remove it. The 10th Generation Accord is a mid-size car produced by GAC Toyota, with a body length, width, and height of 4893mm, 1862mm, and 1449mm respectively, and a wheelbase of 2830mm. The front suspension type is MacPherson independent suspension, and the rear suspension type is multi-link independent suspension.
I remember that time when I took apart the door panel of my 10th-gen Accord, mainly to upgrade the audio system. The tools required were quite simple—just a Phillips screwdriver and a plastic pry bar were enough. I started by prying open the small plastic cover on the door handle, which revealed two hidden screws underneath. Once those were removed, the panel loosened up. Then, I carefully pried along the edges of the door panel, listening for the clicking sounds that indicated the clips were releasing. It’s important not to use too much force, as the door panel is plastic and can crack easily. Inside, there were wires connected to the window switch—just press the clip on the connector gently to safely disconnect it. The whole process took about 20 minutes, with the key being to stay patient and avoid breaking any wires or clips. When reassembling, make sure all parts align properly, and double-check the wiring before testing the window function. If unsure, it’s best to have a friend supervise to avoid any mishaps.
