How to Remove the Door Panel of Honda City?

[ReeseRose]

Method for removing the door panel of Honda City: 1. Inside the door handle, there is a seal plug covering the screw. Remove the seal plug to access the screw, then unscrew it; 2. Remove the plastic decorative clip next to the A-pillar inside the door; 3. Along the edge of the door trim panel, release each plastic retaining clip. The Honda City has dimensions of 4440mm in length, 1695mm in width, and 1495mm in height, with a wheelbase of 2600mm. The front design of the Honda City closely resembles that of the new Fit, featuring very pronounced lines on the front fenders and a dual waistline design on the body. The rear styling somewhat resembles the current Honda Crider.

[MacMiranda]

I've disassembled the door panels of my Honda City several times before, and the process is actually quite straightforward. First, locate the hidden clips and screws along the edges of the interior trim panel. There are usually one or two screws beneath the door handle—just unscrew them with a screwdriver. Then, use a plastic pry tool to gently lift the panel starting from the bottom. Avoid using metal tools to prevent scratching the interior. A good sense of touch is important; you should hear a slight click as the clips release. Continue prying upwards until the panel loosens, then carefully disconnect the wiring connectors for the power windows or other buttons. Remember to turn off the car's power to avoid short circuits. The whole process takes about half an hour. After removal, check if any clips are damaged and replace them if necessary. This is also a good opportunity to clean out dust or upgrade the audio wiring. Patience is key, and having the right tools on hand ensures you won’t damage the car.

[DelClaire]

I was extra careful when attempting to remove the door panel that time. As a beginner, I first consulted Honda's user manual to avoid mistakes. The initial steps were straightforward: locate the screw positions along the door panel edges—the City typically has anchor points under the armrest and handle. Use a Phillips screwdriver to remove all visible screws. Then, gently insert a plastic pry tool from the bottom of the panel and gradually work upward to release the clips, avoiding excessive force to prevent plastic breakage. Once the panel loosens, remember to disconnect the internal wiring connectors by pinching the plugs with your fingers instead of yanking them to avoid damaging the terminals. After removal, inspect the clips for integrity—replace any loose ones with new parts. The entire process requires a quiet environment and meticulous observation, noting each step's details for reassembly.

[VanAlan]

To remove the Fit door panel, first prepare the necessary tools: a plastic pry bar and a screwdriver. Start by removing all screws from the door handle area. The Fit's design typically includes several clip points, so gently pry the panel upward along the edges. Be cautious of the internal wiring connectors—ensure the car is powered off when disconnecting to prevent short circuits. After removal, inspect the clips for any damage to avoid rattling noises during reassembly. The entire process takes about 15 minutes. With experience, you can expand to tasks like cleaning or simple modifications.