How to Remove the Door Panel of Baojun 730?
3 Answers
Steps to remove the door panel of Baojun 730: First, remove the triangular panel inside the door, located at the upper left corner of the door interior. There is a small clip inside the triangular area; after removing the clip, unscrew the fixing screw on the handle. Then, starting from the position indicated at the front lower or rear lower corner of the front door, pry up all seven clips of the front door trim panel one by one. After that, you can use a tool to remove the door panel. The Baojun 730 is a family MPV product under SAIC-GM-Wuling Baojun, with body dimensions of 4710mm in length, 780mm in width, and 1740mm in height, and a wheelbase of 2750mm. The Baojun 730 is equipped with two engines: a 1.5L naturally aspirated engine and a 1.5L turbocharged engine.
Removing the door panel of a Baojun 730 isn't as difficult as you might think. I've done it several times myself, mainly to replace the window switches. All you need is a Phillips screwdriver and a plastic pry tool. Start by locating the screws near the door handle—there are usually two or three hidden ones. After unscrewing them, carefully pry open the edges since the clips are fragile; don't force it. Remember, there are electrical components inside, like the side mirror adjustment plug, so disconnect them gently. The whole process takes about 15 minutes, but first-timers might need more time—it's best to work in a well-lit area. Once removed, you'll often find dust buildup on the back of the panel, so wiping it down is a good idea. If you encounter stubborn clips, don't rush—check video tutorials for guidance. When reassembling, align the panel properly and press firmly to secure it. Doing this yourself saves repair costs and builds handy skills.
It was my first time removing the door panel of a Baojun 730, and I was quite nervous. It took some time to gather the tools—just a screwdriver and plastic pry tool from a basic toolbox. I initially thought it would be a major disassembly job, but then discovered the screws were hidden under the inner door handle cover. Once the cover was off, they were easy to spot. Next, I had to carefully pry open the clips along the door edge, making sure to go slow and avoid scratching the leather surface. Midway through, I encountered the window cable connector and hesitated on how to unplug it—turns out a gentle push released it. The whole process took less than 10 minutes. Newcomers shouldn’t worry; just mentally prepare. After opening it, I noticed the leather was slightly loose, likely due to misaligned clips, so I adjusted them. I’d recommend taking photos of the original positions beforehand to avoid confusion during reassembly. Finishing gave me a huge sense of accomplishment, and I’d also remind everyone to regularly check door seals to prevent water damage.
