How to Remove the Central Control Screen of Lifan Maiwei?
3 Answers
Use a plastic pry tool to remove the plastic trim panels on both sides of the center cup holder near the legs. Only after removing these two panels can you see the screws. Next, remove the leather trim strips on both sides of the gear lever. Except for the two screw positions, the rest of the leather trim strips are held by clips and can be pried off. Remove the two fixing screws at the bottom, then pull the entire air vent panel upwards from below to pry it off. Remember to disconnect the wiring harness at the back before removing the main unit.
I've disassembled similar center control screens before, and the method is relatively simple but requires careful attention. First, prepare the necessary tools: plastic pry tools and a small Phillips screwdriver are essential. Disconnect the negative terminal of the car battery and wait for 10 minutes to prevent electric shock. Then, starting from the edge of the display, use the pry tool to evenly apply force and release the panel clips, being careful not to scratch the trim. Once you see the mounting screws, remove them—there are usually 2-4, so keep them safe. Next, unplug the connectors by gently pressing the clip and pulling them out. Take your time during the process, and if you encounter resistance, check for any hidden clips. I recommend taking photos before disassembly to reference when reassembling. If you're a beginner, it's best to seek help from a professional shop to avoid damaging the circuits or screen.
Last month I attempted to disassemble the center console of my Maiwei to replace the touchpad. Step one was turning off the power and removing the key, using plastic pry tools. Starting from one side of the dashboard, I slowly pried up the panel, noticing Lifan designed very tight clips—avoid yanking hard. Whenever I spotted screws, I unscrewed and stored them safely. The trickiest part was disconnecting the wires: I nearly tore a ribbon cable that time, but later managed to safely detach it by gently releasing the connector latch with my fingernail. The whole process shouldn't be rushed; it took me under 20 minutes but beware of static. After disassembly, I found significant dust buildup inside and cleaned it while at it. Reassembly went smoothly. Personally, I find DIY rewarding, but using professional anti-slip tools is crucial.
