How to Remove the Center Control Screen of the Equinox?
3 Answers
To remove the center control screen of the Equinox, follow these steps: 1. Locate the interior trim strip at the top of the center console. 2. Use a pry tool to remove the trim strip and a short screwdriver to unscrew the screws. 3. Hold both sides of the center console and pull it backward to remove the screen. Details about the Equinox: 1. Dimensions: The new vehicle measures 4646/1843/1688mm in length, width, and height, with a wheelbase of 2725mm. 2. Powertrain: The new Equinox replaces the current 1.5T L4 engine with a 1.3T L3 engine, delivering a maximum power of 121kW (165PS).
I personally disassembled the Equinox's center console screen recently, and it felt quite straightforward. First, make sure the car is turned off and the key is removed—safety comes first. Use a plastic pry tool to gently pry open the trim panel from the edge of the screen, being careful not to use too much force as there are many clips. Once opened, you'll see several mounting screws; remove them with a Phillips screwdriver by turning counterclockwise. Then, gently pull out the screen, but remember it's still connected by wiring harnesses—take photos to note the position of each cable. After unplugging all connectors, you can fully remove the screen. The whole process shouldn't take more than 20 minutes if you take your time. After removal, you can clean or upgrade the system, but test all functions before reassembly. If you encounter resistance, don't force it—it might mean the clips aren't aligned. Wearing gloves is recommended to prevent static scratches on the screen.
I've disassembled the center console screens of several Equinox models, and the method isn't too difficult. Just prepare a pry tool and a Phillips screwdriver to get started. After cutting off the car's power, pry open the edge trim from below the screen, and gently lift it to remove. There are a few small screws inside that can be loosened and removed directly. When pulling the screen outward, be mindful of the wiring harness connectors with locking clips—press and pull them apart. Keep all movements gentle to avoid scratching the interior. Once removed, you can check for loose connections or clean out dust. An additional reminder: avoid plugging in power while working on the car to prevent short circuits. If unsure, refer to the vehicle manual's FAQ section—most of the time, doing it yourself saves more time than visiting a shop.
