How to remove the CD panel of Lavida?

[AmeliaLee]

The method to remove the CD panel of Lavida: Take out a flat-head screwdriver, first remove the control panel with wiring harness, then use the flat-head screwdriver to pry from the edge between the control panel and the door trim panel. After prying it open, you will see 4 Torx screws. Remove them and unplug the wiring to complete the process. Lavida is a compact car launched by SAIC Volkswagen, with length, width and height of 4670mm, 1806mm and 1474mm respectively, and a wheelbase of 2688mm. It is equipped with a 1.5L naturally aspirated engine, with a maximum power of 83kw and maximum torque of 145nm, matched with a 5-speed manual or 6-speed automatic transmission.

[VonAaliyah]

To remove the Lavida's CD panel, I think sharing a few practical tips as an experienced car owner is helpful. Just prepare a plastic pry tool and a Phillips screwdriver; first disconnect the battery's negative terminal to prevent short circuits. Gently pry open the decorative cover from the bottom or edge of the panel, where hidden screws are often located—remove them and then slowly release the clips. Carefully disconnect the wiring at the back without pulling too hard to avoid damaging the connectors. The entire process takes about 15-20 minutes. Wearing gloves is recommended to prevent scratches, and ensure the car is parked on a level surface in a quiet environment. Remember to clean off dust, and if the clips are misaligned, pause and avoid forcing them to prevent panel cracks. After completion, test the wiring to ensure everything works properly—DIY saves both hassle and a bit of money.

[Jeremiah]

Last time, as a beginner, I successfully removed the Lavida CD panel by learning step by step. Simple tools were prepared: a screwdriver and a small pry bar; I first watched tutorial videos online. Starting from the lower right corner of the panel, I pried gently and slowly, avoiding haste to prevent damage to the interior. Upon discovering the securing screws, I unscrewed them, and when pulling out the panel, I encountered connecting wires—gently pressing the clips to disconnect them. I made the mistake of using excessive force and damaged a small accessory, but later learned to mark the plug positions for easier reassembly. The entire process took about 10 minutes. I recommend wearing glasses for dust protection and disconnecting the power supply, making the first attempt very safe and encouraging more DIY repairs afterward. Remembering the details clearly and keeping the car clean made the job easy to handle.

[AddysonLynn]

After years of driving, I believe removing the CD panel must be done carefully to prevent accidents. The design of the Lavida is prone to damage, so always disconnect the battery before starting to avoid short-circuit risks. Use plastic tools to gently pry open the edges, locate and remove the screws, but don’t rush to pull the panel forcefully. Slowly disconnect wiring connectors to prevent breakage. If the clips are stubborn or the interior trim is hard to pry, stop immediately and don’t take risks—it’s best to seek professional repair. The entire process takes about 10 minutes, with safety as the top priority. Keep the work area dust-free for a secure operation. Don’t underestimate this small task—electrical issues can lead to major trouble.