How to Remove the Beetle Headlight?

[RichardRose]

First, turn the tire to one side, remove the 3 plastic screws on the side, and after taking them off, you will see another fixing screw inside. After removing the screws and placing a towel in between, take out the screws on the middle grille and the bolts on the headlight, then lift the clip slightly and pull it outward.

[LaElena]

I've taken apart the Beetle headlights several times before, and I find the job quite straightforward. First, pop open the hood and crouch down facing the headlight assembly. There are usually two or three Phillips screws on top—loosen and remove them with a screwdriver. Then, pay attention to the plastic clips along the edges. Don’t yank them forcefully; instead, use a flathead screwdriver or a plastic pry tool to gently release each clip corner, being careful to avoid breakage. Once the screws and clips are removed, the headlight will loosen slightly, but don’t forget the wiring connector at the back—press down its small release tab before pulling it out steadily. The whole process takes about 10 to 15 minutes, and all you need are a screwdriver and a pry tool—no need to overcomplicate it. After removal, you can check the bulb condition or clean the inside of the lens to prevent dust from affecting lighting performance. Just remember not to work on the headlights while they’re hot, and be cautious of touching heated components to avoid burns.

[CourtneyDella]

The first time I took apart a Beetle headlight, I was a bit flustered until a friend taught me how. Prepare a pair of gloves to prevent scratches and bring a flashlight to illuminate the engine compartment. Squat in front of the car to locate the headlight position. After loosening the top screws, it’s easy to remove, but the edge clips are crucial—avoid using metal tools to pry hard, as plastic clips may break. Gently wiggle the headlight left and right to let it loosen gradually. There’s a small button on the wiring connector; press it to unplug, but don’t rush to avoid breaking the wires. After removing the headlight, place it on a stable surface for inspection or repairs. The whole process requires patience and steadiness—beginners should ideally have someone guide them for safety. This method is simple and cost-effective, saving you repair fees by doing it yourself.

[Andrew]

The key point to remove the Beetle's headlight lies in the fixing points inside the engine compartment unit. The screws are usually cross-shaped and can be easily unscrewed before moving it aside. Plastic clips are located around the headlight and can be released by gently prying with a plastic tool to avoid excessive force damaging the parts. The wire connector must first have its locking mechanism unlocked before being pulled out, requiring smooth and gentle handling. The entire process only requires basic tools, making it convenient and efficient. A common challenge is stuck clips, but avoid forceful pulling—try different angles with patience.