How to Remove the Automatic Gear Shift Knob of Hyundai Verna?
3 Answers
Open the dust cover, remove the dust-proof leather, and pull the leather between the gear shift knob and the armrest upward by hand to open it. The leather is tied to the gear lever with a string. Flip the leather upward to see it, and cut the string to separate the leather. Put the cover back, press the leather, and expose the lower part of the gear shift knob. Cut off the black plastic wrapped around the iron gear lever under the shiny ring of the gear shift knob with a knife, then push downward to remove the shiny ring. Finally, remove the gear shift knob.
I've disassembled my Hyundai Elantra's automatic gear shift lever several times, so I have some experience. You'll need some basic tools: a Phillips screwdriver, plastic pry tools or flathead screwdrivers, and possibly some gloves. First, make sure the car is turned off and parked on level ground, preferably with the key removed. Then gently pry off the trim around the gear lever – these panels on the Hyundai Elantra tend to get stuck, so go slowly to avoid scratches. Next, remove the screws securing the gear shift lever, usually one or two Phillips screws. After loosening them, carefully pull the lever upward to remove it. Don't pull too hard as there might be wiring connectors to disconnect. The whole process takes about ten minutes, but if you're doing it for modification or internal cleaning, remember to take photos to mark positions for reassembly. When modifying, adding some lubricating grease can extend its service life. Overall, doing it yourself saves both money and time compared to going to a repair shop.
As a beginner learning car repair, I was quite nervous when I last removed the automatic gear shift lever of a Hyundai Elantra. First, prepare the tools: just a simple Phillips screwdriver and a small pry tool, no expensive equipment is needed. The steps are: after turning off the car, sit in the driver's seat, gently pry open the plastic decorative cover at the base of the gear shift lever—this cover is snap-on, so don't force it. Then locate the screw holes, remove the fixing screws, and slowly pull the gear shift lever upward. It's normal to feel some resistance when pulling; don't yank hard to avoid breaking any wires. The whole process should be slow and steady—it took me twenty minutes to complete. I recommend wearing thin gloves for better grip and to keep your hands clean. If you accidentally touch any electrical connectors, disconnect the power first to avoid short circuits. After removal, check if dust needs to be cleaned or if new parts need to be replaced—this can greatly help with daily driving. Practicing like this can give beginners a lot of valuable experience.
