How to Remove the Airbag of Haval H6?
2 Answers
Haval H6 airbag removal steps are as follows: 1. Remove the screw on the left side of the Haval H6 steering wheel. 2. Then remove the screw on the right side of the steering wheel. 3. Remove the screw below the steering wheel. 4. Unfasten the wiring harness clip of the steering wheel airbag. 5. Remove the horn grounding inside the steering wheel. 6. Pry open the yellow lock on the airbag, push the unlocking buckle, and the airbag can be removed. Additional information: 1. The airbag control module is generally located in front of the gear shift lever or underneath it. 2. The electronic airbag system is a passive safety protection system. When used in conjunction with seat belts, it can provide effective collision protection for occupants.
I've dealt with removing the airbags from a Haval H6 multiple times, but I must remind you that safety comes first—the risks are genuinely high. Here's the procedure: First, disconnect the negative terminal of the battery and let the car discharge completely for about 10 minutes to minimize the chance of accidental airbag deployment. After that, remove the steering wheel and carefully locate the clips or screws on the airbag module. Gently pry or loosen them, avoiding excessive force that might disturb the wiring. The entire process requires anti-static tools because the airbag contains explosives that can cause injury if triggered. I strongly advise against DIY attempts for non-professionals, as mistakes could damage the airbag system or even trigger fault codes in the car's computer, leading to costly repairs. Airbags are life-saving devices, and removal is typically done during recalls or replacements. If you're not familiar with automotive electronics, take it to an authorized Haval service center—they have specialized equipment and expertise. Additionally, store the removed airbag properly to avoid compression, and during routine maintenance, always monitor the airbag warning light for early detection of potential issues.
