How to Remove the Airbag from a Porsche 718 Steering Wheel?
3 Answers
Porsche 718 steering wheel airbag removal steps are as follows: 1. Release the steering wheel fixing lever. 2. Pull the steering wheel to the outermost position. 3. Adjust the locked lever behind the steering wheel, pry the spring in the direction of the arrow, and detach the airbag from the column. 4. Use skillful force to remove the dust cover on the innermost side of the steering column cover. 5. After removing the upper cover, release the lower cover buckle and remove it. 6. After removing the cover, you will see the steering wheel airbag hooks; use a T20 to pry both sides and gently pull the airbag outward. 7. Use a 15MM socket to directly remove the wheel.
As a DIY enthusiast and car owner, I’d like to share my experience removing the airbag from a Porsche 718 steering wheel. The key is safety preparation: first disconnect the negative battery terminal and wait about ten minutes for the system to discharge, preventing accidental airbag deployment. Basic tools like a Phillips screwdriver or Torx wrench are all you need—the 718’s steering wheel has small rear covers that can be pried open to reveal the airbag’s mounting screws. Once unscrewed, the airbag module will loosen; carefully pull it while being mindful of spring clips snapping back, then disconnect the wiring harness. The entire process should be done in a clean, well-ventilated space—I recommend wearing safety goggles just in case. After completion, double-check connections to avoid triggering warning lights. The 718’s steering column has a delicate design, so avoid excessive force; magnetic tools are ideal to prevent drops. While DIY saves money and is rewarding, it carries risks—beginners can supplement with video tutorials for guidance.
Safety first is my principle when removing airbags. The airbag in the Porsche 718 is located at the center of the steering wheel. Before removal, the battery negative terminal must be disconnected and the wires isolated, waiting for half an hour to allow the capacitor energy to dissipate. Then remove the plastic cover beneath the steering wheel and gently pry it open to reveal the airbag mounting bolts. The airbag is secured by an internal spring mechanism and needs to be slowly pulled out while carefully disconnecting the connector; any rapid movement could trigger the airbag, causing physical injury. I don't DIY unless I have full protective gear; professional technicians are safer because they have testing tools to avoid hidden dangers. I share this because I've seen a neighbor get eye abrasions while attempting it, so emergency repairs should be handled at authorized shops. The process may seem simple but has many risk factors; regular maintenance can keep the airbag system more stable.
