How to Remove the Air Conditioning Blower of Peugeot 307?
3 Answers
First, remove the three plastic panels, then the protruding deflector at the front bottom. Next, reach in from below to remove the resistor, take off the deflector, and use a socket wrench and a Torx hex key to remove the blower. Here is some relevant information about the Peugeot 307: 1. Model: The Dongfeng Peugeot 307 features an integrated steel body that significantly enhances the vehicle's strength. On one hand, in the event of a collision, specially designed impact-absorbing zones reduce the impact on passengers, improving their protection. On the other hand, the overall body ensures excellent grounding performance, fully guaranteeing driving safety. 2. Power Performance: In terms of power performance, the Dongfeng Peugeot 307 shares the same design philosophy as other models in its series. It features a transversely mounted engine, front-wheel drive, four-wheel independent suspension, and comprehensive active and passive safety devices, with human-centric design fully reflected throughout. The wheelbase is 2.61 meters long. The vehicle measures 4.47 meters in length, 1.76 meters in width, and 1.51 meters in height, with a trunk capacity of 506 cubic decimeters.
I've previously disassembled the air conditioning blower on a Peugeot 307, and the whole process was actually quite simple. First, you need to remove the glove compartment on the passenger side, which is usually secured to the panel with several screws that can be loosened with a Phillips screwdriver. After removing the glove compartment, the blower becomes visible—remember to disconnect the negative terminal of the battery first to prevent short circuits. The blower itself is held in place by a few screws, which can be removed with a socket wrench. Then, gently pull out the main unit, being careful not to yank too hard to avoid damaging the wiring. The connector has a clip; press it down to disconnect. The entire process took me about twenty minutes, and a basic home automotive toolset is sufficient—saving money while learning a new skill. Adding some lubricant when cleaning out the dust can extend its lifespan. Make sure not to mix up the positions, and align the glove compartment properly with its slots when reinstalling. Safety first—wear gloves and goggles to prevent scratches.
As a car owner, I dismantled the blower motor of my 307 by myself last year. Starting from the glove box, I opened the cover, located and unscrewed the fixing screws, then carefully pulled out the box to avoid damaging the interior. The blower motor is located at the rear of the panel. Before disconnecting the wires and plugs, I first disconnected the car's power supply and carefully removed the clips with pliers. As a beginner, I was a bit nervous, so I recommend watching a video tutorial to familiarize yourself with the steps. During the disassembly, you might find dust accumulation; cleaning it up can make the air conditioning quieter. The whole process saved me repair costs and took about an hour to complete, allowing me to check if the fan blades were intact. Replacing the blower motor afterward wasn't difficult; just make sure to align the clips properly when reconnecting. When putting the glove box back, test the air conditioning to ensure it works properly and avoid any strange noises. Learning some basic maintenance skills is definitely worth it to keep the car running longer.
