How to Remove ETC from the Windshield?

[VonAugust]

You can use a hairdryer to heat the double-sided adhesive on the back of the ETC device, then carefully remove it with a small plastic scraper. Below is some related information about ETC: 1. ETC, which stands for Electronic Toll Collection in Chinese, is an automatic toll collection system for highways or bridges. It works through dedicated short-range communication between the vehicle-mounted electronic tag installed on the windshield and the microwave antenna in the ETC lane at the toll station. This system uses computer networking technology to process transactions with the bank, allowing vehicles to pass through highway or bridge toll stations without stopping to pay fees. 2. Please note that the ETC device cannot be removed and installed on another vehicle for use. Different vehicle types have different highway toll rates, so the ETC device is dedicated to a specific vehicle.

[Una]

When I drive for long periods, I know removing the ETC tag isn’t difficult. Just use a hairdryer set to low heat and warm the tag for a few minutes to soften the adhesive, then peel it off slowly. Be gentle to avoid leaving residue or scratching the glass. After removal, there might be some sticky residue—I usually clean it with an alcohol wipe, which is quick and effective. If you’re relocating the tag or switching to a new car, first find a clean, flat spot on the windshield free of dust, and wipe it down before reapplying. Always do this in daylight for better visibility and safety. For maintenance, check the tag regularly to ensure it’s secure and address any issues early to avoid hassle.

[MacMorgan]

As a DIY enthusiast, I've tried various methods to remove ETC tags. Essential tools include a hairdryer or heat gun - use medium to low heat to evenly warm the back of the tag for about 30 seconds until the adhesive softens, then slowly lift from the corner and peel it off. For stubborn adhesive, spray specialized adhesive remover like WD-40 and let it sit for a minute for easy cleanup. Always wear gloves during the process to protect against burns or flying glass fragments. After cleaning the glass, ensure the surface is smooth and residue-free before reapplying or relocating the tag. This hands-on approach saves garage fees and gives a sense of accomplishment. Remember not to rush or use excessive force, as the tag itself might get damaged and become unusable.

[ArabellaAnn]

I emphasize safe ETC removal. Keep the heating control temperature below 70°C to prevent glass cracking from thermal expansion. Peel slowly at an angle under 30 degrees to minimize scratch risks. Clean residual adhesive promptly with isopropyl alcohol after removal to maintain clear visibility. When transferring tags during vehicle replacement, always park properly before operation.

[SanJasper]

Experience tells me that forcibly removing the ETC can cause issues. Once, a friend's label adhesive was too strong, and using a cloth soaked in warm water to soften it before removal worked effectively. Nowadays, there are spray-type adhesive removers on the market—just spray, wait five minutes, and easily wipe off the residue, making the process much simpler. When removing, be careful not to damage the label base so it can be reused. After cleaning, the glass looks as good as new without affecting its appearance.