How to Remove and Install the Wiper Blades on Nissan Qashqai?
3 Answers
Nissan Qashqai wiper blade removal and installation method is as follows: 1. Push the wiper towards the front of the vehicle to the fixed position with slightly more force. Press the fixing button device of the wiper blade, hold the wiper blade at the same time, shake it upwards, and remove the wiper blade. 2. Open the two small buckles of the wiper to remove the old rubber strip. 3. When installing the prepared new rubber strip, use your fingers to spread the two metal pieces and insert them into the first groove. Do not install both sides at the same time, but do it side by side. 4. After the new rubber strip is successfully installed, follow the reverse order of the disassembly process to smoothly reinstall the wiper.
I've been driving the Qashqai for several years, and replacing the wiper blades is simple but requires attention to detail. First, turn off the car for safety, and when lifting the wiper arm, place a towel or cloth on the windshield to prevent the arm from snapping back and damaging the glass. The Qashqai uses a hook-type connector—locate the small button or clip at the connection point, press and slide gently, and the old blade can be pulled out. If the rubber strip on the old blade is hardened, cracked, or shows signs of aging, it's time for a replacement. Hold the new blade at the correct angle, align it with the arm hook, and push until you hear a click to lock it in place. After installation, spray some water to test the wiping performance; if it's uneven or makes noise, readjust. It's recommended to replace them every six months, ensuring you buy the correct size for the Qashqai (check the owner's manual or packaging for the model number). Poor wiping increases driving risks, especially in rainy conditions. Doing it yourself saves time and money, and it's a good opportunity to clean the windshield of grease and dust, ensuring clear visibility and peace of mind.
As a DIY-loving car enthusiast, I find replacing the X-Trail wiper blades super easy—just a few minutes' work. First, park and turn off the engine to protect the windshield, then gently lift the wiper arm and cushion it with a soft cloth to prevent scratches. Locate the release tab at the connection point (X-Trail’s hook-style design is common), press the central protrusion with your finger, and slide out the old blade. Align the new blade with the hook and snap it securely into place, ensuring it sits flush against the glass without wobbling. For best results, clean the windshield with dedicated glass cleaner before installation. Monitor your wipers for skipping or streaking as signs for replacement—swap them every 6–12 months using X-Trail-compatible blades to save costs. DIY replacement requires no tools and zero expense, plus you’ll pick up handy maintenance skills. Just avoid cheap blades—opt for quality to minimize frequent changes.
