How to Remove and Install the Taillight of Qashqai?

1 Answers
Sheila
07/29/25 10:50pm
The method for removing the taillight of Qashqai is as follows: 1. The taillights are mainly located on both sides of the rear of the vehicle, and the fastening screws are inside the car; 2. Open the tailgate to see two plastic fastening buckles inside, and use tools to remove them; 3. Open the interior trim panel to see the fastening screws inside, and remove them directly; 4. When taking out the taillight, be careful not to break the wiring harness of the taillight, and place the old taillight properly. More information about Qashqai is as follows: 1. Qashqai is the first work since the establishment of Nissan Europe Design Center. The name comes from the nomadic tribes living in the desert area of Iran, meaning "urban nomads", and its positioning is between compact SUV and hatchback. 2. Qashqai is equipped with a newly developed 1.2-liter turbocharged gasoline engine by Nissan, with peak horsepower and torque output reaching 113bhp and 190Nm respectively.
Was this review help?
2
4
Share
More Forum Discussions

Why is it difficult to shift gears in an automatic transmission?

There are mainly three reasons for difficulty in shifting gears in an automatic transmission: 1. Operational factors: Incorrect operation by the driver, where the speed does not match the gear, leading to difficulty in shifting. This can be resolved as the driver gains experience and becomes more proficient. 2. Clutch factors: Rust on the transmission's primary shaft can prevent the clutch driven disc from moving properly, resulting in poor return and difficulty in engaging gears along the normal path. 3. Transmission factors: Old transmission fluid needs to be replaced. If not replaced in time, its lubrication effectiveness decreases, making gear shifting more strenuous.
19
4
Share

What causes the C4L to indicate an engine fault?

C4L indicating an engine fault may be caused by spark plug carbon deposits, dirty throttle body, leaking fuel injectors, cylinder wear, or oxygen sensor failure. Below is an introduction to the 2019 230THP automatic leading model Citroën C4L: Powertrain: Equipped with a 1.2-liter turbocharged 3-cylinder engine, paired with a 6-speed automatic manual transmission. Body dimensions: Length, width, and height are 4675mm, 1780mm, and 1500mm respectively, with a wheelbase of 2710mm. Chassis: The drivetrain is front-engine, front-wheel drive, with a MacPherson independent front suspension and a torsion beam non-independent rear suspension, featuring a unibody structure.
8
0
Share

How to Properly Use a Homemade Tire Pressure Gauge?

Correct usage measures for homemade tire pressure gauges: 1. Do not exceed the maximum pressure indicated on the dial. 2. Check tire pressure when the weather is hot or cold. 3. For tire valve stems without caps, remove any dirt before use. 4. Inflate to the tire pressure recommended by the tire manufacturer. 5. The accuracy of the tire pressure gauge will be affected if it is dropped or subjected to severe impact. 6. Pressure unit conversion: 1BAR=14.5PSI=1.02KG/CM2 (PSI stands for pounds per square inch). 7. Measure when the tires are cold. 8. Tighten the tire pressure gauge connector onto the tire valve stem until the gauge pointer reaches the highest position.
10
0
Share

What are the functions of the buttons in the Sylphy?

Here are the introductions to the functions of the buttons in the Sylphy: Electronic Stability System: It can effectively prevent the vehicle from skidding, fishtailing, or other loss of control situations. Parking Radar: The central control screen displays images, and the radar will sound an alarm when obstacles are detected. Auto Start-Stop: This function allows the engine to temporarily shut off. The vehicle will restart when the driver's foot leaves the brake pedal. Temperature Zone Synchronization: When this function is turned on, changing the temperature in the driver's zone will synchronize the changes in the other temperature zones. After turning off this function, each zone can be set individually to meet the needs of passengers in different positions.
7
5
Share

Does Land Rover have sedans?

Land Rover currently does not produce sedan models. The brand primarily focuses on luxury all-terrain SUV series, which are well-known for their SUV lineup and robust off-road capabilities. Below are the specifications of the 2022 Land Rover Defender 90 3.0T-P400XS: Body dimensions: Length x Width x Height are 4583mm, 2008mm, and 1969mm respectively, with a wheelbase of 2580mm. Chassis: The drivetrain features front-engine four-wheel drive, with a front suspension of double-wishbone independent suspension and a rear suspension of multi-link independent suspension, built on a unibody structure.
15
0
Share

Why does the Vios sell less than the Santana?

The reason why the Vios sells less than the Santana may lie in the Santana's advantages in appearance, power, and interior. Here are the relevant introductions: Appearance: The Santana is a compact car with a novel exterior design that meets the aesthetic requirements of young people for cars. Power: Taking the 2019 1.5L National V manual fashion version Santana as an example, it can deliver a maximum of 110Ps horsepower. The use of a 5-speed manual transmission ensures quick and smooth gear shifting without frustration, with consistent gear engagement and faster acceleration. Interior: The button layout is tilted towards the driver, making driving convenient and safe. Appropriate embellishments of small decorations add a sense of fashion to the interior space. Compared to the Toyota Vios's interior, the seat materials are softer, providing a more comfortable ride.
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.