How to Remove and Install the Rearview Mirror of Baojun 730?

[LaDeclan]

Baojun 730 is an MPV with a body size of 4780mm in length, 1780mm in width, and 1740mm in height, a wheelbase of 2750mm, a fuel tank capacity of 52L, and a curb weight of 1500kg. The method for removing and installing the rearview mirror of Baojun 730 is as follows: 1. Use a flat-head screwdriver to pry open the edge between the mirror housing and the rearview mirror base. 2. Press the lower part of the rearview mirror with your hand, then remove the flat-head screwdriver. 3. Insert the flat-head screwdriver into the gap between the right side of the mirror and the housing, and pry open the clip inside. 4. Pry open the clip that fixes the rearview mirror to complete the removal.

[JulianaLynn]

To remove and install the Baojun 730's side mirror, I think it's best to proceed step by step without rushing. For removal, you'll need some tools like a Phillips screwdriver and a small pry bar. Locate the area near the mirror on the inner side of the door, where a plastic trim panel covers the mounting points. Gently pry open the trim panel with the small pry bar, being careful not to use too much force to avoid scratching the door panel, revealing the screw holes inside. Then, use the screwdriver to remove those fastening screws. If the mirror is power-adjustable, carefully disconnect the wiring harness, ensuring the power is off for safety. Once removed, set it aside for handling. For reinstallation, simply reverse the process: first reconnect the wiring harness, making sure it's not reversed; then secure the screws, tightening them to prevent loosening; finally, snap the trim panel back into place. Remember to test the mirror's angle adjustment after installation to ensure proper functionality. The entire process takes about 10-15 minutes, with the main challenge being careful handling of the plastic components to avoid cracking them. To be safe, work in a well-lit area or even record a video to follow along, preventing mistakes. When replacing the mirror glass, make sure to buy the correct specifications, with OEM parts being the most reliable.

[DiSadie]

Hey, I've done the side mirror removal and installation several times. It's relatively simple for cars like the Baojun 730. First, you need to find the right moment, like doing it in the garage on a cloudy day. The first step is to pry open the door handle area a bit - there are several screws hidden inside that just need to be unscrewed. But don't force the mirror body itself, as you might damage the pivot point. For electric mirrors, turn off the car power first and unplug the connector slowly. When installing, just reverse the removal steps, making sure all screws are tightened properly. I learned this the hard way once when I didn't tighten them enough and the mirror rattled while driving. For safety, wear gloves and avoid touching electrical parts. Also, why remove it? Mostly it's because the mirror glass is broken or needs adjustment - just buy a matching model to replace it. No special tools needed, a regular tool set is sufficient. After finishing, test the angle and folding function - if everything works, you're good to go. The whole process shouldn't take more than 20 minutes - going too fast actually increases the chance of mistakes.

[VonCorbin]

Removing and installing the Baojun 730 side mirror is not difficult, but remember safety first. First, disconnect the negative terminal of the battery to avoid short circuits. When removing, pry open the inner plastic cover to expose and unscrew the screws. For electric mirrors, unplug the wiring connector. During installation, reconnect the wires, secure the screws, and snap the cover back in place. The whole operation can be completed within 15 minutes. If in doubt, visit a professional shop for convenience and safety.