How to Remove and Install the Rear Taillight of a Sagitar?
3 Answers
Here is the method for removing the rear taillight of a Sagitar: 1. Take out the car key of the Sagitar and use it to open the trunk. 2. Observe the inner lining near the rear taillight that needs to be removed, take out a flat-head screwdriver, and gently pry open the clip with the screwdriver. 3. Disconnect the wiring harness connector. Take out the flat-head screwdriver, press the wiring harness connector with it, then slightly pull outward to remove the connector. 4. Remove the taillight nuts. Take out a small ratchet with a 10mm socket and remove these two nuts. The method for installing the rear taillight: Operate from bottom to top.
As a car enthusiast, I’d like to share the disassembly method: Removing the rear taillight of a Sagitar is quite simple. First, open the trunk—the inner trim panel covers the back of the light. Use a plastic pry tool to gently release the clips or screws; avoid pulling hard to prevent breaking the clips. After removing the trim, the wiring harness section of the engine will be exposed. The taillight is typically secured by three to four screws—check the model and use the appropriate screwdriver to loosen all screws. Then, gently wiggle the light assembly and pull it out, ensuring you first unplug the wiring connector. The connector has a small clip—press it to release before safely separating it. When installing the new light, reverse the steps: Align the position, firmly plug in the wiring until you hear a click to lock it, then re-tighten the screws and secure the trim. The whole process takes about 30 minutes, and the basic tool required is just a screwdriver. I recommend wearing gloves to prevent scratches, as the light’s glass is fragile. Regularly clean the contact points to reduce oxidation issues. After completion, test all lights to ensure they function properly—only then is the job done.
Removing and installing the Sagitar rear taillight is a common task in my auto repair work. First, ensure vehicle safety by turning off the engine and disconnecting the power. Open the trunk interior panel and gently pry open the clips with a trim tool to expose the taillight area. The taillight screws are usually located in corners; avoid excessive force when loosening to prevent thread stripping. Before removing the light, disconnect the wiring harness - some models have anti-theft designs requiring you to press the clip before separation. When installing the new light, align it with the screw holes and tighten securely; ensure the connector is firmly seated before reassembling the interior panel and securing the clips. Throughout the process, prevent short circuits or contact oxidation that may cause lighting issues; a multimeter can be used for basic circuit testing. Select tools appropriate for the material, as plastic components are fragile. This maintenance extends taillight lifespan.
