How to Remove and Install the Navigation System in the 2019 Trumpchi GM6?
4 Answers
Method for removing and installing the navigation system in the 2019 Trumpchi GM6: 1. Remove the CD player in the car. There are several interior panels covering the screws. Pry off the panels to expose the screws; 2. After removing the screws, gently take out the CD player. There are two connectors at the back. Release the clips and separate the wiring harness from the CD player; 3. Install the GPS antenna for the navigation system. Place the antenna inside the dashboard from the passenger side, then position the GPS antenna vertically on the right side of the dashboard; 4. Take the navigation system and connect it according to the original wiring method. After connecting, secure the longer wires with tape to prevent noise caused by the wires hitting the car while driving; 5. Screw the screws back in place and reattach the interior panels. The 2019 Trumpchi GM6 has body dimensions of 4780mm in length, 1860mm in width, and 1730mm in height, with a wheelbase of 2810mm.
I previously disassembled the navigation system of a 2019 Trumpchi GM6, and it went quite smoothly. You'll need tools like plastic pry bars and a Phillips screwdriver. First, disconnect the negative terminal of the battery to avoid any short-circuit risks. Then, gently pry open the center console panel along the edges—avoid using excessive force to prevent scratching the interior. Once removed, you'll find several screws securing the navigation unit; unscrew these to pull out the host. Disconnect all cable connectors to remove the old navigation unit. To install the new one, reverse the steps: reconnect all cables, ensuring proper alignment to avoid incorrect insertion, then secure the screws and snap the panel back into place. The whole process may take about an hour. Remember to check the new navigation system's compatibility with your specific vehicle model—some upgraded systems might require additional software configuration, so don’t skip this step to avoid rework. After installation, test all functions to ensure everything works properly.
I was a bit nervous the first time I removed the navigation system, afraid of messing up the car. I recommend you first check tutorials on owner forums or YouTube videos to learn. Basic steps: Disconnect the negative battery terminal for safety, use plastic tools to gently pry open the corners of the panel, take it slow and don't rush. Locate the screws near the head unit and unscrew them, then gently pull out the head unit without yanking the cables. After removing the old navigation, when installing the new device, check if the interfaces match the GM6's original design. Once installed, reconnect the power and test. The process can have minor issues like broken panel clips or loose connectors, so beginners should prepare spare parts or seek help from a mechanic. The removal and installation take a while, so set aside about an hour and a half. Additional tip: If upgrading the navigation system, check if the map software needs updating to avoid future hassles.
Common mistakes when removing the navigation system include damaging the interior with metal tools. Correct procedure: Disconnect the negative battery terminal, use plastic pry tools to gently remove the panel. Then unscrew the mounting bolts, remove the head unit and disconnect the plugs. When installing a new navigation system, ensure all connectors are secure and check that the clips are intact before reassembling the panel. Note that many owners skip the manual steps, leading to malfunctions or incorrect port connections. It's advisable to take photos of the original setup before disassembly. Compatibility is crucial, especially when switching to an Android system that needs to be adapted to the GM6 system. The process is straightforward but requires attention to detail to avoid subsequent issues like circuit short circuits.
