How to Remove and Install the Navigation System in Honda Fit?

[JuliannaAnn]

Remove the panel covering the navigation system to expose the mounting screws. Unscrew and take out the navigation unit, then disconnect the wiring harness. Below are relevant details about Honda Fit: 1. The GAC Honda Fit enjoys immense popularity, colloquially nicknamed "Super Sports Car." To enhance competitiveness and attract younger consumers, Fit launched a new model with upgrades targeting youth preferences - the next-generation Sport Edition Fit. 2. All Fit models come standard with driver/passenger airbags, child seat anchors, engine immobilizer, ABS anti-lock braking, EBD brake force distribution, and cabin air filtration/pollen filter to meet daily needs. 3. The Fit adopts the same styling as the US version. Key exterior changes include adding a honeycomb mesh to the front grille, accentuated by dual silver chrome trim strips, with integrated headlights on both sides.

[AutumnDella]

I've done the removal and installation of the Fit's navigation system a few times, and I've got a good feel for it. The most crucial part of the whole process is preparing the tools first: a flathead screwdriver, interior trim pry bars, and it's best to buy a dedicated removal kit—cheap and effective. Start by turning off the engine and disconnecting the battery's negative terminal to prevent short circuits, otherwise, you might see sparks. Then, pry open the plastic panels around the navigation system, starting from the gap at the top edge of the dashboard, and do it slowly—don't use excessive force to avoid scratching the interior. The exposed navigation unit is usually secured with a few screws; unscrew them carefully and set them aside. At this point, disconnect the wiring harness at the back—there's a connector that releases with a gentle press. After removing the navigation, check for any damage. To reinstall, just reverse the steps: reconnect the wires, tighten the screws, align and push it back into place, snap the panels back on, and finally reconnect the battery to test the navigation. I recommend taking photos as you go to keep track of the positions, so you don't get confused during reassembly. The navigation model might require slight adjustments depending on the year—my older Fit was simpler than the newer models. It takes about twenty minutes to finish, but beginners should take their time.

[ODaniella]

The steps to remove the Fit's navigation system are actually quite clear, let me share the process. First, ensure the car is parked and the battery's negative terminal is disconnected—safety first. Gather the necessary tools: a small screwdriver and pry tools are essential. There are panels around the navigation; start prying gently from the corners to avoid cracking. Once the panel is removed, you'll see screws—unscrew them and keep them safe to avoid dropping them inside. When unplugging wires, remember their color-coded positions, and take photos for easy reassembly. Remove the navigation slowly, avoiding any forceful pulling. Installation is the reverse process: first, reconnect the wires, align the unit properly, and secure it with screws. The key is to press the panel flat and ensure it snaps into place without gaps. Use the right tools—the Fit's clip design can be fragile at times, so proceed with care. Overall, I find the process simpler than changing a tire, and you can usually do it yourself, saving a trip to the shop. After completion, test the navigation to ensure it works properly.

[OPatrick]

Honda Fit Navigation Removal and Installation: Don't Take It Lightly, I Remind Everyone of Safety Details. Key Points: Must disconnect power to prevent static electricity from damaging circuits; use plastic pry tools when removing panels to avoid vehicle damage. Simple Steps: Pry open the cover, unscrew bolts, disconnect cables, remove the head unit. During installation, ensure all connections are secure and properly positioned. Risks: Incorrect cable removal may cause short circuits; excessive force can damage interior trim; improper handling of screws may scratch surfaces. Beginners should consult the manual or online videos for assistance, especially with older vehicles where clips may be brittle and prone to breaking. The process takes about half an hour—complete it carefully with patience and slow movements for a secure result.