How to Remove and Install the Manual Transmission Knob of Buick Excelle?
3 Answers
For the manual transmission knob of the Buick Excelle, simply hold the gear lever knob of the 2006 model old Buick Excelle and rotate it counterclockwise. Below is an introduction to the Buick Excelle: 1. Buick Excelle: The Buick Excelle (Buick-Excelle) is based on General Motors' global platform. The prototype of the Excelle is the latest global mid-size sedan developed by General Motors, designed and developed under the leadership of GM Daewoo Auto & Technology (GMDAT). 2. Exterior: The all-new Excelle adopts Buick's new-generation family design language, featuring the brand's signature winged grille with dark mesh textures and a high-gloss chrome shield-shaped outline, exuding youthful vitality. The winged headlights and grille form a diving angle, creating a dynamic appearance. The side of the car combines flowing body lines with high-gloss surfaces, presenting a low-front, high-rear diving posture. The winged taillights echo the headlights, while the rear spoiler reduces wind resistance and enhances handling, improving fuel efficiency. 3. Interior: The new car continues Buick's 360-degree wraparound integrated design, with lightweight design elements throughout. The center console features a high-contrast visual effect with integrated high-gloss black and chrome trim, highlighting a sense of technology. The seats are upholstered in rare suede fabric for the segment, providing a comfortable riding experience.
Last time I spent an entire afternoon replacing the manual shift knob on my Excelle. The toughest part was dealing with that retaining clip underneath. You have to lift the shift boot to expose the metal shaft, then use needle-nose pliers to remove the clip. If it's rusted in place, spraying some WD-40 and waiting 30 minutes makes it much easier. When installing the new knob, pay attention to the orientation - you'll hear a satisfying 'click' when it's properly seated. Always test the gearshift throw afterward - once I found second gear unusually stiff because the clip wasn't fully seated. These minor modifications are quite rewarding; after switching to a metal knob, the gear engagement sounds much crisper.
The removal and installation of the manual gearshift knob on the Excelle isn't actually difficult, the key is using the right tools. Just prepare a socket wrench and needle-nose pliers. First, remove the side trim panel of the center console to expose the gear lever base. There's a retaining clip at the bottom of the knob - carefully pry it open with pliers. When installing the new knob, make sure the splines on the knob align with those on the gear lever, otherwise shifting gears may become stiff. If the original knob was glued, you can use a heat gun to soften the adhesive before twisting it off. Once I encountered stripped threads on the knob and temporarily fixed it by wrapping several layers of PTFE tape. After replacement, it's recommended to test drive for half an hour to check if the knob loosens. Doing it myself saved 200 yuan in labor costs.
