How to Remove and Install the Honda Vezel Glove Box?
3 Answers
The removal and installation method for the Honda Vezel glove box is: Open the vehicle's glove box, remove the piston buffer latch on the right side, rotate the fixed button on the inner right side of the glove box counterclockwise. There are knobs on both the left and right sides inside, which need to be removed. The glove box can then be opened to its maximum extent. Use a clip removal tool to take out the fixed pins on both sides of the glove box. After removing these pins, the glove box can be taken off. Taking the 2020 Honda Vezel as an example, it belongs to the compact SUV category with body dimensions of: length 4328mm, width 1772mm, height 1605mm, wheelbase 2610mm, fuel tank capacity 50l, and curb weight 1227kg.
Removing and installing the Honda Vezel's glove box is actually not difficult. I just tried it on my own car, and the process went quite smoothly. First, prepare simple tools like a Phillips screwdriver or plastic pry bar to protect the interior parts from scratches. After opening the glove box, you'll see plastic clip structures on both the left and right sides—usually, gently pressing inward with your fingers or a tool will release them. Avoid using excessive force to pull, as this could break the clips and cause permanent damage. When slowly pulling out the entire box, be mindful of small dampers or wire connectors that might be attached at the back, especially on the 2020 Vezel model. Once removed, it's a good opportunity to clean out accumulated dust inside the box or replace the cabin air filter, saving a trip to the dealership. Before reinstallation, align the box to its original position and gently push it back in. You should hear two distinct clicks, indicating the clips are securely fastened. Finally, test the opening and closing to ensure smooth operation. The whole process takes about 10 minutes. It's best to wear gloves to prevent pinching your fingers, and if unsure, consult the vehicle manual for model-specific details.
DIY removal of the Vezel glove box is quite hassle-free, and I've tinkered with plenty after driving for over a decade. First, turn off the engine and clear out the clutter inside the box, then find a comfortable position to avoid back strain. Next, open the glove box door and inspect the interior—there are usually hidden clips on both sides that can be released by applying gentle inward pressure with your fingers. When pulling out the box, do it steadily and slowly to prevent connected components like dampers from disengaging. During reinstallation, align the box with the frame and push it back firmly until it feels secure. This method also allows you to check if the filter is dirty, enabling timely replacement to improve cabin air quality. In terms of tools, a plastic pry bar is safer than a metal screwdriver, as it's less likely to scratch the plastic. From experience, ensure adequate lighting during disassembly to avoid mistakes in dim conditions. If it feels tricky, don’t force it—simple troubleshooting or watching online tutorials can save time and money compared to visiting a repair shop.
