How to Remove and Install the Camry Side Mirror Cover?
4 Answers
Here is the detailed tutorial for removing and installing the Camry side mirror cover: 1. Handle the mirror glass by pressing the top of the glass with your hand to lift the bottom, then grab the bottom and pull it outward firmly to remove the glass. 2. After removing the glass, if the mirror has a heating function, disconnect the wire connector of the heating element; if not, skip this step. 3. You can clearly see the screws located at the edge; unscrew them. There are also screws at the bottom of the mirror and under the middle component that need to be unscrewed. 4. The middle component can then be removed. The exterior mirror removal is now complete.
I've taken apart the Camry's side mirror housing several times, and it's pretty straightforward. First, turn off the engine to avoid any risk of electric shock. As for tools, a small screwdriver or plastic pry bar will do. Locate the connection point between the mirror glass and the housing—there are usually small clips or screws hidden beneath the glass. Gently pry the glass out, being careful not to use too much force, or you might crack the glass, which would be a real bummer. The housing is secured with a few screws; once you unscrew them, you can slowly remove it. When installing the new housing, make sure it's properly aligned, and the clips are in place before tightening the screws. Finally, test if the glass is loose. I recommend taking photos before disassembling to avoid forgetting the original setup. The whole process takes about ten minutes, but be careful with the wiring—don't pull too hard, or you might damage the turn signal function.
As a DIY enthusiast, I find removing and installing the Camry side mirror housing quite an interesting task. I've replaced the housing myself because it got scratched accidentally. A small knife and a screwdriver from my toolbox were sufficient for the job. Start by gently prying open the mirror glass section—there might be adhesive or clips underneath, so peel it off slowly. The housing has screws; once loosened, it can be removed. When installing the new housing, ensure it fits snugly into place and tighten the screws securely to prevent loosening from road vibrations. This is also a good opportunity to clean out any dust or water accumulation inside—I once discovered mildew spots in mine, but now with the new housing, it's much cleaner. Be careful not to scratch the mirror glass; wrap your tools with a soft cloth. The whole process is straightforward, low-cost, and saves a lot on repair fees while teaching you a bit about car components.
Removing the side mirror cover is not difficult; you can see the screws once the mirror is pried open. Gently pry the edge of the mirror with a small tool, remove it, then loosen the screws to take off the cover. When installing the new cover, align it and tighten the screws. Remember to turn off the power to avoid any risks.
