How to Remove Aged Paint Protection Film?

1 Answers
DiDelilah
07/30/25 7:06am
To remove aged paint protection film, simply use an EP-type adhesive remover for paint protection film. Below are the advantages of paint protection film: 1. Enhance vehicle brightness: Paint protection film can increase the glossiness of the vehicle body by 520, and it is relatively stable and durable, usually lasting three to five years without issues. 2. Improve paint resistance to UV aging: The transparent coating of the paint protection film effectively enhances the paint's resistance to UV aging, preventing easy discoloration or yellowing. Paint protection film acts as a transparent protective layer, isolating the car paint from the external environment and providing relatively effective protection for the paint.
Was this review help?
15
3
Share
More Forum Discussions

Is the Toyota Camry Front-Wheel Drive or Rear-Wheel Drive?

Camry adopts front-engine, front-wheel drive. The eighth-generation Camry is equipped with a new 2.5L Dynamic Force Engine. The new 2.5L Dynamic Force Engine has a maximum output power of 154kw and a maximum torque of 250Nm. Introduction to the Camry: 1. Body dimensions: length 4885mm, width 1840mm, height 1455mm, wheelbase 2825mm. 2. Suspension: the front suspension uses MacPherson strut independent suspension, and the rear suspension is an E-type multi-link independent suspension.
2
3
Share

Will the car air conditioning vent be damaged if water enters?

A small amount of water entering the car air conditioning vent will not cause damage. The reason is that water entering from the air conditioning intake can be discharged through the air conditioning drain and will not remain inside the car air conditioning system. Here is more information about car air conditioning: 1. When designing air conditioning systems, manufacturers conduct leak tests by spraying water into the intake or outlet vents to ensure that all water flows out through the drain and does not leak from the car's shell. 2. The air conditioning ventilation system effectively ensures fresh air inside the vehicle while also defogging the windshield. China has strict standards for air quality in car air conditioning, requiring a minimum of 20 cubic meters of fresh air per person per hour.
18
4
Share

How many cylinders does the MG6 engine have?

The MG6 is equipped with a four-cylinder engine. This model uses a 1.5-liter four-cylinder turbocharged engine with a maximum power output of 124 kW and a peak torque of 250 Nm. The engine reaches its maximum power at 5,500 rpm and delivers peak torque between 1,700 and 4,300 rpm. It features direct fuel injection technology and an aluminum alloy cylinder head and block. The engine is paired with either a 6-speed manual or a 7-speed dual-clutch transmission. The MG6 is positioned as a compact car, with dimensions of 4,695 mm in length, 1,848 mm in width, and 1,462 mm in height, and a wheelbase of 2,715 mm. In terms of features, the car comes equipped with keyless start, an electronic parking brake, and a vehicle stability control system, among other configurations.
16
0
Share

What Does the Second Maintenance of a Car Include?

Car second maintenance includes the following items: 1. Engine. After performing the three cleans and three filters on the engine, ensure that the engine starts easily, runs smoothly, meets exhaust emission standards, and shows no abnormal noises, water leakage, oil leakage, electrical leakage, or air leakage. 2. The free travel of the steering and the toe-in meet the requirements. The steering should be light, flexible, and free from wobbling or deviation of the front wheels during driving. 3. The free travel of the clutch meets the requirements. It should be easy to operate, completely disengage, engage smoothly, have no abnormal noises, and show no oil leakage in the hydraulic system. 4. Check whether the transmission, drive, and front half-shaft are well lubricated, reliably connected, easy to shift, and free from oil leakage. 5. Check whether the brake pedal and service brake meet the requirements, which include good braking performance, no deviation, and no oil leakage. 6. Normal tire pressure. 7. The suspension arms and shock absorbers are fixed properly, functioning normally, and the wheel hub bearings do not overheat during driving. 8. The generator, starter, lights, instruments, signal lights, buttons, switches, and auxiliary equipment are complete, intact, and functioning normally. 9. Perform a full car wash and maintenance.
10
4
Share

What engine does the Changan CS35 use?

Changan CS35 is equipped with the Blue-Core efficient H series 1.6L engine. The following is the relevant introduction about Changan CS35: 1. The CS35 is powered by the new generation Blue-Core H series efficient 1.6L engine, which has a maximum output power of 125 horsepower and a maximum torque of 160N·m. 2. Its maximum power reaches 121kW, and the maximum torque reaches 250N·m. It has three major advantages: powerful, clean, and quiet. The engine idle noise is only 38.5 decibels, which is lower than the industry average of 45 decibels.
18
0
Share

Can a Car That Uses 95 Octane Fuel Use 92 Octane Fuel?

A car that uses 95 octane fuel cannot use 92 octane fuel, as this may lead to insufficient anti-knock properties, increased engine failure rates, and issues such as higher fuel consumption, increased carbon deposits, and clogged fuel injectors. Reason Analysis: Generally, the fuel type recommended for a vehicle is indicated on the fuel tank cap. It is advisable to use the specified fuel or a higher octane rating, but not a lower one. A car that uses 92 octane fuel can use 95 octane fuel, but a car that uses 95 octane fuel should not use 92 octane fuel. The primary difference between different octane ratings lies in their anti-knock performance, which is a crucial indicator of fuel quality. 92 octane gasoline has an octane rating of 92 and is suitable for mid-range vehicles (with lower compression ratios). 95 octane gasoline consists of 95% isooctane and 5% n-heptane, and it is recommended for engines with higher compression ratios. 98 octane gasoline has an octane rating equivalent to a mixture of 98% isooctane and 2% n-heptane. The advantages of 98 octane gasoline are "two highs and two lows": higher anti-knock performance and power output, and lower harmful substances and exhaust emissions. Fueling Precautions: Vehicles should not arbitrarily switch to a lower octane fuel. Using a lower octane fuel may cause premature combustion, leading to engine knocking. Additionally, incomplete combustion can result in increased carbon deposits, clogging fuel lines and injectors, as well as reduced vehicle power and higher fuel consumption.
13
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.