How to Put a Range Rover Evoque Tow Vehicle in Neutral?

Can an Electronic ID Card Be Used for Subject Three Test?

Electronic ID cards can be used for the Subject Three test. The "Interim Resident Identity Card Management Measures of the People's Republic of China," formulated and issued by the Ministry of Public Security, have been in effect since October 1, 2005. Chinese citizens residing within the territory of the People's Republic of China, who urgently need to use their resident ID cards during the application, renewal, or replacement of their resident ID cards, can apply for an interim resident ID card. Below are some tips for the Subject Three test: Follow the voice instructions: Listen carefully to the voice prompts for Subject Three and follow the instructions accordingly. Be sure not to perform any actions before the voice prompt ends; wait until it finishes before proceeding to the next step. Pay attention to special zones: In many areas, the voice prompts no longer remind candidates of special zones such as school zones, bus stops, and crosswalks. However, candidates must perform corresponding deceleration or yielding actions based on the project signs and road markings. For school zones, apply the brakes 10 meters before the project sign, keeping the speed below 30 km/h. For bus stops, apply the brakes 10 meters before the project sign, keeping the speed below 30 km/h. For crosswalks, apply the brakes to decelerate within 30 meters before the crosswalk, and stop to yield if pedestrians are crossing.

16

1

Share

Can Tires Be Replaced with Different Brands?

It is possible to replace car tires with different brands, but the tires on the same axle must be identical. This means the two front tires must be the same, and the two rear tires must also match. Mixing brands on the same axle is not allowed, though the front and rear tires can be from different brands. Below is some relevant information about tires: Tire Lifespan: The wear lifespan of tires is typically 30,000 to 50,000 kilometers. If the tires have not reached the wear limit or mileage but have been in use for 5 years or show significant sidewall cracking, they should be replaced. Tire Material: The main component of tires is rubber. The maximum storage and anti-aging period for rubber—from natural latex to EPDM and nitrile—does not exceed 10 years. The average service life of various rubber products in use is 3 to 5 years.

18

5

Share

What is the speed limit when crossing an intersection?

When passing through an unsignalized intersection without speed limit signs, the maximum driving speed should not exceed 30 kilometers per hour, with tractors, electric vehicles, and wheeled special machinery vehicles not exceeding 15 kilometers per hour. It is advisable to slow down and yield to pedestrians. This approach ensures greater safety when encountering intersections. Content introduction: Content 1: When approaching an intersection, you should slow down in advance, observe the road, and then pass through at a relatively low speed. Content 2: When crossing an intersection at night, remember to switch from high beams to low beams. Content 3: Pay attention to the movements of pedestrians and anticipate their actions in advance. Content 4: When turning at an intersection, if there are heavy vehicles such as dump trucks or trucks on the outer side, smaller vehicles on the inner side should be cautious and yield, as heavy vehicles have more blind spots.

13

2

Share

How to Remove Adhesive from Car Glass?

Methods for removing adhesive from car glass are introduced as follows: 1. Essential Balm: Using essential balm to remove adhesive from glass is a common method. Apply the essential balm to the adhesive on the glass, wait a moment for the adhesive to soften, then wipe it clean with a damp towel. 2. Alcohol: Alcohol is also effective for removing adhesive because it is a good solvent that can dissolve many types of glue and stains. Spray alcohol on the adhesive or soak a towel in it and wipe gently. 3. Hand Cream: Hand cream contains a certain amount of surfactants, which can quickly penetrate the adhesive and the surface of the car window, providing a moistening and dissolving effect, thereby removing the adhesive.

10

4

Share

How Often Should the Battery Be Replaced?

Car batteries should be replaced every 2 to 3 years. The car battery is an essential part of the vehicle and can be divided into traditional lead-acid batteries and maintenance-free batteries. Since the battery uses lead-calcium alloy for the grid frame, the amount of water decomposed during charging is minimal, and the evaporation rate is also low. Additionally, the sealed structure of the casing releases very little sulfuric acid gas. Compared to traditional batteries, it does not require adding any liquid and has the characteristic of long power storage time. Below are some tips for car battery maintenance: Avoid prolonged parking: The battery installed in the car will self-discharge over time when left unused. It is best to drive the car at least once a week, with a trip duration of at least 20 minutes, to allow the battery to recharge while driving. Close windows before turning off the engine: The power for operating car windows and sunroofs comes from the battery. Therefore, it is advisable to close all windows before turning off the engine rather than after, or even using the long-press lock button method to close windows after leaving the car. Keep the battery clean and tidy: Regular inspections are an effective way to extend the battery's lifespan. Use a professional battery electrode brush or an old toothbrush to clean dust and corrosion from the positive and negative terminals. Apply a layer of Vaseline or grease to the contact surfaces to form a protective film.

20

3

Share

Automotive Air Conditioning Pressure Testing Method

The testing method for automotive air conditioning pressure is as follows: 1. On the high and low pressure pipelines of the air conditioning system: there are pressure test ports installed respectively, which can not only test the pressure of the air conditioning refrigerant pipeline but also charge or discharge the refrigerant. The test port is equipped with a one-way valve with the same structure as a tire valve core. If the one-way valve is not tightly sealed, the refrigerant in the pipeline will leak, causing the air conditioning system to fail to cool. To prevent this phenomenon, ensure that the plastic sealing cap on the test port is securely screwed onto the upper end of the test port. If the plastic sealing cap is missing, it should be replaced promptly. Otherwise, dirt and impurities will accumulate inside the test port, not only causing the one-way valve to seal poorly but also affecting the normal use of the test port. 2. If the air conditioning is not cooling: a simple method is to unscrew the plastic sealing cap of the test port and gently press the one-way valve with a clean, slender screwdriver. If the refrigerant is sufficient, white mist-like refrigerant will spray out. If no refrigerant overflows, it indicates that the refrigerant in the air conditioning pipeline has completely leaked.

2

0

Share

How to Put a Range Rover Evoque Tow Vehicle in Neutral?

Can an Electronic ID Card Be Used for Subject Three Test?

Can Tires Be Replaced with Different Brands?

What is the speed limit when crossing an intersection?

How to Remove Adhesive from Car Glass?

How Often Should the Battery Be Replaced?

Automotive Air Conditioning Pressure Testing Method

How much fuel does a car consume when running the air conditioner overnight?

Is pulling up the gear lever on an electric tricycle for high gear or low gear?

What are the body dimensions of the Toyota Yaris L?

Can You Use the Brake to Control Speed in Subject Two Driving Test?