How to Pull Out a Car Dent?

1 Answers
DylanLee
07/30/25 10:21am
You can purchase a dent repair kit to pull out the dent. The principle of a car dent repair kit is to use tools such as a hot glue gun and a bridge-type suction puller to adhere the suction cup to the car body and then pull out the dented area using the principle of tension. Here are the specific steps: 1. First, clean the surface of the dent. Apply hot glue to the suction cup using the glue gun, then gently press it onto the dented area. 2. If the dent is relatively large, you can use multiple suction cups and use tools to pull them outward together until the dent is repaired. Then, remove the old glue using a plastic scraper.
Was this review help?
2
2
Share
More Forum Discussions

What is the engine model of the Toyota RAV4?

Toyota RAV4 uses two types of engines in total. The 2.0L engine model is 6ZR-FAE, and the 2.5L engine model is 5AR-FE. Both of these engines are four-cylinder. The model equipped with the 2.5L naturally aspirated engine is a hybrid version. The 2.0L naturally aspirated engine of the RAV4 delivers 171 horsepower and a maximum torque of 209 Nm, while the 2.5L naturally aspirated engine produces 178 horsepower and a maximum torque of 221 Nm. The dimensions of the Toyota RAV4 are 4630 mm in length, 1855 mm in width, and 1685 mm in height, with a wheelbase of 2660 mm. The RAV4 is also equipped with the VSC vehicle stability control system, 6 airbags, TRC traction control system, HAC hill-start assist control, and an automatic limited-slip differential.
11
4
Share

Where is the rear fog light fuse of Haval H6?

Located in the engine compartment, next to the battery. Press the latch and simultaneously lift the fuse box cover upwards to open it. Introduction to fog lights: Fog lights generally refer to automotive fog lights. They are installed at the front and rear of the vehicle to illuminate the road and provide safety warnings during rainy or foggy weather, enhancing visibility for both the driver and other road users. Structure: In addition to the front high beams, low beams, headlights, and parking lights, and the rear running lights and brake lights, most vehicles also have a set of fog lights in inconspicuous locations at the rear. Rear fog lights are red signal lights installed at the rear of the vehicle to make it more visible to other road users in low-visibility conditions such as fog, rain, or dust. They emit a stronger light intensity than the tail lights.
11
4
Share

What is the reason for the lifting failure of the Mercedes-Benz S300?

Check if the four shock absorbers are at the same height. If they are level, the issue is usually a faulty air pump for the shock absorbers. A professional diagnostic tool is still needed for a precise check. Introduction to the Car Chassis: The car chassis consists of four parts: the transmission system, the running system, the steering system, and the braking system. The chassis supports and installs the car engine and its various components and assemblies, forming the overall shape of the car. It also receives the power from the engine to enable the car to move and ensure normal driving. Functions of the Car Chassis: The power generated by the car engine is transmitted to the driving wheels through the transmission system. The transmission system has functions such as deceleration, speed change, reversing, power interruption, wheel differential, and axle differential. Working in conjunction with the engine, it ensures the normal operation of the car under various conditions, providing good power performance and fuel economy.
20
0
Share

Does the Volkswagen CC leak water?

FAW-Volkswagen CC's frameless doors will not leak water as long as the door seal strips are not aged and the doors have not been involved in accidents. Sunroof water leakage: There are generally two situations for sunroof water leakage: one is clogging of the sunroof drainage channel; the other is displacement or "lifting" of the sunroof sealing strip. Therefore, it is advisable to regularly clean the sunroof to maintain the cleanliness around the drainage channel. Also, do not forget to use high-pressure air jet equipment aimed at the drainage pipe during regular car washes to blow away any dirt inside the pipe. Car waterproof adhesive failure causing water leakage: Water leakage usually occurs at the openings of doors and the trunk. The main reason for this is often the waterproof strips, which may be defective, aged, or cracked, allowing rainwater to seep in. Reapplying adhesive specifically designed for waterproof strips can completely prevent water leakage.
3
1
Share

Where is the Mazda 3 fog light located?

The Mazda 3 fog light is located below the headlights, featuring a circular design. The fog light is activated using the lever on the left side of the steering wheel—simply rotate the lever to the fog light position to turn it on. Fog lights are typically installed at the front and rear of the vehicle. In foggy conditions with low visibility, they enhance the driver's sight by increasing illumination distance. The yellow fog light, in particular, has strong light penetration, improving visibility for both the driver and other road users, allowing oncoming vehicles and pedestrians to spot each other from a greater distance. The Mazda 3 has dimensions of 4662mm in length, 1797mm in width, and 1445mm in height, with a wheelbase of 2726mm. It is a 4-door, 5-seater sedan equipped with a 6-speed manual transmission, naturally aspirated 1.5L L4 engine.
8
2
Share

Does the Golf 7 come with an engine guard plate?

The Golf 7 does not come with an engine guard plate as standard equipment; it requires aftermarket installation of a model-specific one. Below is some information about automotive engine guard plates: 1. An engine guard plate is a protective device designed specifically for various vehicle models to shield the engine. 2. Its primary purpose is to prevent mud from accumulating around the engine and to protect the engine from damage caused by impacts with uneven road surfaces during driving. Additional information: 1. Regarding body dimensions, the Golf 7 measures 4259mm in length, 1799mm in width, and 1452mm in height, with a wheelbase of 2637mm. 2. The Golf 7 is equipped with the EA211 series 1.6L and 1.4T engines. While the displacement remains the same as the Golf 6, the power parameters of these two engines have changed. The 1.6L engine delivers a maximum power of 81 kW and a maximum torque of 155 Nm, paired with a 5-speed manual or a 6-speed automatic transmission.
2
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.