How to Play Videos in Roewe RX5?

Where is the outdoor temperature sensor of Volkswagen Lavida located?

There should be two outdoor temperature sensors for the Volkswagen Lavida, one near the radiator and another near the engine water outlet. Here is some extended information: 1. Exterior: The front face design is quite different from previous A-class cars under the Volkswagen brand. In terms of body line design, the Lavida features a sharp waistline while retaining a side profile similar to the Octavia. 2. Body dimensions: The car measures 4670/1806/1474mm with a wheelbase of 2688mm. The Lavida uses the standard MQB platform without incorporating Volkswagen's latest technological details, significantly reducing its digital foundation. Both versions share the same powertrain combination, featuring a 1.4T engine paired with a 7-speed DSG transmission.

8

0

Share

Where is the negative terminal of the Volvo S90 battery?

The positive terminal of the battery will be covered with a red cap, and opening the cap will reveal a terminal with a fuse, indicating the positive terminal. If the battery cables are connected in the car, the positive terminal will have more wires and fuses, while the negative terminal is grounded with only one wire. The battery will clearly be marked with '+' and '-' signs. More maintenance information is as follows: 1. Open the battery water filler cap and check if the water level is at the normal position: There are usually upper and lower limit marks on the side of the battery for reference. If the water level is below the lower mark, distilled water must be added. If distilled water is not immediately available, filtered tap water can be used as an emergency measure. Do not add too much water; the standard is to fill it to the middle between the upper and lower marks. 2. Check if the battery is charging properly: If you have a multimeter, measure the voltage across the battery terminals after starting the engine. It must exceed 13V to be considered normal. If the charging voltage is too low, a professional should inspect the charging system. If you don't have a multimeter, you can use a visual method: After starting the engine, open the battery water filler cap and check if there are bubbles in each cell.

7

0

Share

What is the real fuel consumption of the Maxus EUNIQ5 plug-in hybrid?

The real fuel consumption of the SAIC Maxus MAXUS EUNIQ5 hybrid version is 4.62L/100km; the average fuel consumption of the luxury version is 5.3L/100km. Here are some additional details: 1. Exterior: The overall design of the car is stable and elegant, with a touch of youthful flair. The front features a large closed grille design with blue accents, giving it a stylish look. The split headlights on both sides are sharp and elongated, blending well with the grille and enhancing the visual extension of the front. 2. Powertrain: The car is equipped with a plug-in hybrid system consisting of a 1.3T turbocharged engine and a permanent magnet synchronous motor. The engine delivers a maximum horsepower of 163PS and a peak torque of 230 Nm, meeting the China VI emission standards.

11

0

Share

How Often Should Spark Plugs Be Replaced in Volkswagen Cars?

If they are original spark plugs for Volkswagen cars, they should normally be replaced every 20,000 to 30,000 kilometers. If spark plugs are not replaced for a long time, it can lead to various issues such as electrical leakage in the vehicle's ignition system, increased fuel consumption, reduced power, and most importantly, difficulty in ignition, affecting the normal use of the vehicle. Spark Plug Replacement Interval: Under normal maintenance conditions, spark plugs should be replaced after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine, so it is recommended to follow the user manual. The following standards can be referenced for maintenance and replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for Replacing Spark Plugs: Open the hood, lift the plastic cover of the engine, and remove the high-voltage wires. Mark the position of each cylinder to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. When removing them, check for external debris such as leaves or dust and ensure they are thoroughly cleaned. Place the new spark plugs into the spark plug holes, hand-tighten them a few turns, and then use the socket to tighten them further. Reinstall the removed high-voltage wires according to the ignition sequence and secure the cover.

15

2

Share

What Causes Unstable Idle in a Camry?

The reasons for unstable idle in a Camry may include severe engine carbon buildup, ignition system issues, aging engine components, leaks in the intake manifold or various valves, and excessive dirt accumulation in the throttle body and intake passages. The details are as follows: Severe engine carbon buildup: The most common cause of car shaking is a dirty throttle body or excessive carbon buildup in the fuel injectors. When there is too much carbon inside the engine, the gasoline sprayed by the cold-start injector is largely absorbed by the carbon deposits, resulting in an overly lean air-fuel mixture during cold starts and making it difficult to start. Ignition system issues: Check the condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or weak sparking from the spark plugs can also lead to such faults. Unstable fuel pressure: If you have already cleaned the engine carbon, cleaned the throttle body, replaced the oil seals and spark plugs, but still notice shaking at idle, it could be due to abnormal fuel pump pressure or incorrect readings and poor performance of the intake pressure sensor, which can cause the car to shake. Aging engine components: Car shaking can also be related to worn engine mounts. Engine mounts are essentially the shock absorbers for the engine, responsible for absorbing minor vibrations during operation. If the engine mounts are faulty, these vibrations will be transmitted to the steering wheel and cabin, causing shaking at idle. Leaks in the intake manifold or various valves: When unwanted air, fuel vapor, or exhaust gases enter the intake manifold, the air-fuel mixture becomes too rich or too lean, leading to abnormal combustion. If the leak affects only certain cylinders, the engine will shake more violently, especially during cold idle. Excessive dirt accumulation in the throttle body and intake passages: Too much carbon and dirt in the throttle body and surrounding intake passages changes the cross-sectional area of the air passages, preventing the control unit from precisely regulating the idle air intake. This results in an overly rich or lean mixture and abnormal combustion.

13

1

Share

What is the difference between Volvo S60 T4 and B4?

1. Driving Experience: The power parameters of the two engines are almost identical, with negligible differences. Therefore, the main distinctions lie more in the driving experience. Firstly, the B4 engine utilizes a 48V motor, which delivers smoother starts. The 2022 model also removed the auto start-stop switch button, making it impossible to manually disable the start-stop feature. During vehicle startup, the motor intervenes to bring the engine to the required starting RPM before ignition, effectively eliminating the sensation of startup vibrations and ensuring a seamless experience. In this regard, the B4 engine holds a clear advantage. However, during rainy weather, especially on waterlogged roads, it is advisable for 2022 models to avoid wading through deep water to prevent potential stalling and restart issues. 2. Fuel Consumption: The 2022 B4 model shows a slight reduction in fuel consumption compared to the T4, primarily due to the benefits of the auto start-stop feature, though the difference is not significant, and overall fuel efficiency remains largely comparable. Other differences between these two engines are minimal. Some 2022 model owners have reported engine fault codes with the B-series engines, which were resolved after a software update at the dealership, indicating that the issue was related to software debugging rather than hardware problems, posing no major concern.

19

4

Share

How to Play Videos in Roewe RX5?

Where is the outdoor temperature sensor of Volkswagen Lavida located?

Where is the negative terminal of the Volvo S90 battery?

What is the real fuel consumption of the Maxus EUNIQ5 plug-in hybrid?

How Often Should Spark Plugs Be Replaced in Volkswagen Cars?

What Causes Unstable Idle in a Camry?

What is the difference between Volvo S60 T4 and B4?

Where is the engine number located on the Maxus T60 engine?

How many liters of engine oil should be added to a Volvo S90 T5?

Where is the USB port in Volvo?

What is the difference between Volvo TA and TM?